Debian Codegraph @

rfc1972.html

raw
1 <pre>Network Working Group M. Crawford
2 Request for Comments: 1972 Fermilab
3 Category: Standards Track August 1996
4
5
6
7 <span class="h1">A Method for the Transmission of IPv6 Packets over Ethernet Networks</span>
8
9 Status of this Memo
10
11 This document specifies an Internet standards track protocol for the
12 Internet community, and requests discussion and suggestions for
13 improvements. Please refer to the current edition of the "Internet
14 Official Protocol Standards" (STD 1) for the standardization state
15 and status of this protocol. Distribution of this memo is unlimited.
16
17 Introduction
18
19 This memo specifies the frame format for transmission of IPv6 [<a href="#ref-IPV6" title="&quot;Internet Protocol, Version 6 (IPv6) Specification&quot;">IPV6</a>]
20 packets and the method of forming IPv6 link-local addresses on
21 Ethernet networks. It also specifies the content of the
22 Source/Target Link-layer Address option used the the Router
23 Solicitation, Router Advertisement, Neighbor Solicitation, and
24 Neighbor Advertisement messages described in [<a href="#ref-DISC" title="&quot;Neighbor Discovery for IP Version 6 (IPv6)&quot;">DISC</a>], when those
25 messages are transmitted on an Ethernet.
26
27 Maximum Transmission Unit
28
29 The default MTU size for IPv6 packets on an Ethernet is 1500 octets.
30 This size may be reduced by a Router Advertisement [<a href="#ref-DISC" title="&quot;Neighbor Discovery for IP Version 6 (IPv6)&quot;">DISC</a>] containing
31 an MTU option which specifies a smaller MTU, or by manual
32 configuration of each node. If a Router Advertisement is received
33 with an MTU option specifying an MTU larger than 1500, or larger than
34 a manually configured value less than 1500, that MTU option must be
35 ignored.
36
37 Frame Format
38
39 IPv6 packets are transmitted in standard Ethernet frames. The
40 ethernet header contains the Destination and Source ethernet
41 addresses and the ethernet type code, which must contain the value
42 86DD hexadecimal. The data field contains the IPv6 header followed
43 immediately by the payload, and possibly padding octets to meet the
44 minimum frame size for Ethernet.
45
46
47
48
49
50
51
52 <span class="grey">Crawford Standards Track [Page 1]</span></pre>
53 <hr class='noprint'/><!--NewPage--><pre class='newpage'><span id="page-2" ></span>
54 <span class="grey"><a href="./rfc1972">RFC 1972</a> Transmission of IPv6 Packets Over Ethernet August 1996</span>
55
56
57 +-------+-------+-------+-------+-------+-------+ ^
58 | Destination Ethernet address | |
59 +-------+-------+-------+-------+-------+-------+ ethernet
60 | Source Ethernet address | header
61 +-------+-------+-------+-------+-------+-------+ |
62 | 86 DD | v
63 +-------+-------+-------+-------+-------+------+------+
64 | IPv6 header and payload ... /
65 +-------+-------+-------+-------+-------+------+------+
66
67 Stateless Autoconfiguration and Link-Local Addresses
68
69 The address token [<a href="#ref-CONF" title="&quot;IPv6 Stateless Address Autoconfiguration&quot;">CONF</a>] for an Ethernet interface is the interface's
70 built-in 48-bit IEEE 802 address, in canonical bit order and with the
71 octets in the same order in which they would appear in the header of
72 an ethernet frame. (The individual/group bit is in the first octet
73 and the OUI is in the first three octets.) A different MAC address
74 set manually or by software should not be used as the address token.
75
76 An IPv6 address prefix used for stateless autoconfiguration of an
77 ethernet interface must be 80 bits in length.
78
79 The IPv6 Link-local address [<a href="#ref-AARCH" title="&quot;IP Version 6 Addressing Architecture&quot;">AARCH</a>] for an Ethernet interface is
80 formed by appending the interface's IEEE 802 address to the 80-bit
81 prefix FE80::.
82
83 +-------+-------+-------+-------+-------+-------+------+------+
84 | FE 80 00 00 00 00 00 00 |
85 +-------+-------+-------+-------+-------+-------+------+------+
86 | 00 00 | Ethernet Address |
87 +-------+-------+-------+-------+-------+-------+------+------+
88
89 Address Mapping -- Unicast
90
91 The procedure for mapping IPv6 addresses into Ethernet link-layer
92 addresses is described in [<a href="#ref-DISC" title="&quot;Neighbor Discovery for IP Version 6 (IPv6)&quot;">DISC</a>]. The Source/Target Link-layer
93 Address option has the following form when the link layer is
94 Ethernet.
95
96 +-------+-------+-------+-------+-------+-------+-------+-------+
97 | Type |Length | Ethernet Address |
98 +-------+-------+-------+-------+-------+-------+-------+-------+
99
100
101
102
103
104
105
106
107
108 <span class="grey">Crawford Standards Track [Page 2]</span></pre>
109 <hr class='noprint'/><!--NewPage--><pre class='newpage'><span id="page-3" ></span>
110 <span class="grey"><a href="./rfc1972">RFC 1972</a> Transmission of IPv6 Packets Over Ethernet August 1996</span>
111
112
113 Option fields:
114
115
116 Type 1 for Source Link-layer address.
117 2 for Target Link-layer address.
118
119
120 Length 1 (in units of 8 octets).
121
122
123 Ethernet Address
124 The 48 bit Ethernet IEEE 802 address, in canonical bit
125 order. This is the address the interface currently responds
126 to, and may be different from the built-in address used as
127 the address token.
128
129 Address Mapping -- Multicast
130
131 An IPv6 packet with a multicast destination address DST is
132 transmitted to the Ethernet multicast address whose first two octets
133 are the value 3333 hexadecimal and whose last four octets are the
134 last four octets of DST, ordered from more to least significant.
135
136 +-------+-------+-------+-------+-------+-------+
137 | 33 | 33 | DST13 | DST14 | DST15 | DST16 |
138 +-------+-------+-------+-------+-------+-------+
139
140 Security Considerations
141
142 Security issues are not discussed in this memo.
143
144 References
145
146 [<a id="ref-AARCH">AARCH</a>] Hinden, R., and S. Deering, "IP Version 6 Addressing
147 Architecture", <a href="./rfc1884">RFC 1884</a>, December 1995.
148
149 [<a id="ref-CONF">CONF</a>] Thomson, S., and T. Narten, "IPv6 Stateless Address
150 Autoconfiguration", <a href="./rfc1971">RFC 1971</a>, August 1996.
151
152 [<a id="ref-DISC">DISC</a>] Narten, T., Nordmark, E., and W. Simpson, "Neighbor Discovery
153 for IP Version 6 (IPv6)", <a href="./rfc1970">RFC 1970</a>, August 1996.
154
155 [<a id="ref-IPV6">IPV6</a>] Deering, S., and R. Hinden, "Internet Protocol, Version 6
156 (IPv6) Specification", <a href="./rfc1883">RFC 1883</a>, December 1995.
157
158
159
160
161
162
163
164 <span class="grey">Crawford Standards Track [Page 3]</span></pre>
165 <hr class='noprint'/><!--NewPage--><pre class='newpage'><span id="page-4" ></span>
166 <span class="grey"><a href="./rfc1972">RFC 1972</a> Transmission of IPv6 Packets Over Ethernet August 1996</span>
167
168
169 Author's Address
170
171 Matt Crawford
172 Fermilab MS 368
173 PO Box 500
174 Batavia, IL 60510
175 USA
176
177 Phone: +1 708 840-3461
178 EMail: [email protected]
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220 Crawford Standards Track [Page 4]
221 </pre>