Debian Codegraph @

arch/arm/boot/dts/ti/omap/dra62x-j5eco-evm.dts

raw
1 // SPDX-License-Identifier: GPL-2.0-only
2 /dts-v1/;
3
4 #include "dra62x.dtsi"
5 #include <dt-bindings/interrupt-controller/irq.h>
6
7 / {
8 model = "DRA62x J5 Eco EVM";
9 compatible = "ti,dra62x-j5eco-evm", "ti,dra62x", "ti,dm8148", "ti,dm814";
10
11 memory@80000000 {
12 device_type = "memory";
13 reg = <0x80000000 0x40000000>; /* 1 GB */
14 };
15
16 /* MIC94060YC6 controlled by SD1_POW pin */
17 vmmcsd_fixed: fixedregulator0 {
18 compatible = "regulator-fixed";
19 regulator-name = "vmmcsd_fixed";
20 regulator-min-microvolt = <3300000>;
21 regulator-max-microvolt = <3300000>;
22 };
23 };
24
25 &cpsw_emac0 {
26 phy-handle = <&ethphy0>;
27 phy-mode = "rgmii-id";
28 };
29
30 &cpsw_emac1 {
31 phy-handle = <&ethphy1>;
32 phy-mode = "rgmii-id";
33 };
34
35 &davinci_mdio {
36 ethphy0: ethernet-phy@0 {
37 reg = <0>;
38 };
39
40 ethphy1: ethernet-phy@1 {
41 reg = <1>;
42 };
43 };
44
45 &gpmc {
46 ranges = <0 0 0x04000000 0x01000000>; /* CS0: 16MB for NAND */
47
48 nand@0,0 {
49 compatible = "ti,omap2-nand";
50 reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
51 interrupt-parent = <&gpmc>;
52 interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
53 <1 IRQ_TYPE_NONE>; /* termcount */
54 #address-cells = <1>;
55 #size-cells = <1>;
56 ti,nand-ecc-opt = "bch8";
57 nand-bus-width = <16>;
58 gpmc,device-width = <2>;
59 gpmc,sync-clk-ps = <0>;
60 gpmc,cs-on-ns = <0>;
61 gpmc,cs-rd-off-ns = <44>;
62 gpmc,cs-wr-off-ns = <44>;
63 gpmc,adv-on-ns = <6>;
64 gpmc,adv-rd-off-ns = <34>;
65 gpmc,adv-wr-off-ns = <44>;
66 gpmc,we-on-ns = <0>;
67 gpmc,we-off-ns = <40>;
68 gpmc,oe-on-ns = <0>;
69 gpmc,oe-off-ns = <54>;
70 gpmc,access-ns = <64>;
71 gpmc,rd-cycle-ns = <82>;
72 gpmc,wr-cycle-ns = <82>;
73 gpmc,bus-turnaround-ns = <0>;
74 gpmc,cycle2cycle-delay-ns = <0>;
75 gpmc,clk-activation-ns = <0>;
76 gpmc,wr-access-ns = <40>;
77 gpmc,wr-data-mux-bus-ns = <0>;
78 partition@0 {
79 label = "X-Loader";
80 reg = <0 0x80000>;
81 };
82 partition@80000 {
83 label = "U-Boot";
84 reg = <0x80000 0x1c0000>;
85 };
86 partition@1c0000 {
87 label = "Environment";
88 reg = <0x240000 0x40000>;
89 };
90 partition@280000 {
91 label = "Kernel";
92 reg = <0x280000 0x500000>;
93 };
94 partition@780000 {
95 label = "Filesystem";
96 reg = <0x780000 0xf880000>;
97 };
98 };
99 };
100
101 &mmc2 {
102 pinctrl-names = "default";
103 pinctrl-0 = <&sd1_pins>;
104 vmmc-supply = <&vmmcsd_fixed>;
105 bus-width = <4>;
106 cd-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>;
107 };
108
109 &pincntl {
110 sd1_pins: sd1-pins {
111 pinctrl-single,pins = <
112 DM814X_IOPAD(0x0800, PIN_INPUT | 0x1) /* SD1_CLK */
113 DM814X_IOPAD(0x0804, PIN_INPUT_PULLUP | 0x1) /* SD1_CMD */
114 DM814X_IOPAD(0x0808, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[0] */
115 DM814X_IOPAD(0x080c, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[1] */
116 DM814X_IOPAD(0x0810, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[2] */
117 DM814X_IOPAD(0x0814, PIN_INPUT_PULLUP | 0x1) /* SD1_DAT[3] */
118 DM814X_IOPAD(0x0924, PIN_OUTPUT | 0x40) /* SD1_POW */
119 DM814X_IOPAD(0x093C, PIN_INPUT_PULLUP | 0x80) /* GP1[6] */
120 >;
121 };
122
123 usb0_pins: usb0-pins {
124 pinctrl-single,pins = <
125 DM814X_IOPAD(0x0c34, PIN_OUTPUT | 0x1) /* USB0_DRVVBUS */
126 >;
127 };
128 };
129
130 /* USB0_ID pin state: SW10[1] = 0 cable detection, SW10[1] = 1 ID grounded */
131 &usb0 {
132 pinctrl-names = "default";
133 pinctrl-0 = <&usb0_pins>;
134 dr_mode = "otg";
135 };
136
137 &usb1_phy {
138 status = "disabled";
139 };
140
141 &usb1 {
142 status = "disabled";
143 };