Debian Codegraph @

eyes17/helpFiles/hi/_sources/7.1.rst

raw
1 Temperature measurement using PT100
2 ===================================
3
4 The Resistance Temperature Detector (RTD) is a temperature sensing device whose resistance changes with temperature, typically built from platinum. To measure the resistance across an RTD, apply a constant current, measure the resulting voltage, and determine the RTD resistance. The PT100 is a popular RTD with a resistance of :math:`100 \Omega` at 0°C. Resistance of a PT100 element is related to the temperature
5 by the equation :math:`R(T) = R_0 (1 + AT + BT^2)`, where
6 :math:`A = 3,9083 \times 10^{ 3}` and :math:`B = 5,775 \times 10^{ 7}`.
7
8 Objective
9 ---------
10
11 Record the temperature of a liquid by using a Pt100.
12
13 Procedure
14 ---------
15
16 .. image:: schematics/pt100.svg
17 :width: 300px
18
19 - Make the connections as shown in the figure.
20 - Enter the Gain, Offset error and the Current from CCS
21 - Select the temperature range and time intervals
22 - Select the required parameters and press START
23
24
25 Cooling curve of water is shown in the figure below.
26
27 .. image:: pics/pt100-screen.png
28 :width: 300px
29
30 Discussion
31 ----------
32
33 The accuracy of the measurements can be increased by the following steps.
34
35 Measure the actual current from CCS and enter it in the GUI, it could be slightly
36 different from 1.1mA. The input to A3 is amplified 11 times by
37 connecting :math:`1~k\Omega` resistor from Rg to Ground. The gain and offset should
38 be measured an entered in to the program.