| 1 |
Velocity of sound |
| 2 |
================= |
| 3 |
|
| 4 |
Objective |
| 5 |
---------- |
| 6 |
|
| 7 |
Calculate the velocity of sound by measuring the pressure variation with |
| 8 |
distance. Sound travels as a series of compressions and rarefactions. |
| 9 |
Figure `↓ <#fig:Sound-waves>`__\ (b) shows the High and Low pressure |
| 10 |
regions along the direction of travel, along with output of a pressure |
| 11 |
sensor at corresponding positions. |
| 12 |
|
| 13 |
We can display the pressure variation at any point with respect to the |
| 14 |
variation at the starting point. The phase of the microphone output |
| 15 |
changes as you change its distance from the Piezo. Moving by one |
| 16 |
wavelength changes the phase by 360 degrees. If the phase changes by *X* |
| 17 |
degrees for :math:`\Delta D` cm change in distance, the wavelength is given by |
| 18 |
:math:`\lambda = (360 \times \Delta D)/X`. The velocity of sound can be calculated by |
| 19 |
multiplying the frequency with this. |
| 20 |
|
| 21 |
+----------------------------------------------------------------------------+ |
| 22 |
|.. image:: schematics/sound-velocity.svg | |
| 23 |
| :width: 300px | |
| 24 |
|.. image:: pics/sound-waves.png | |
| 25 |
| :width: 300px | |
| 26 |
+----------------------------------------------------------------------------+ |
| 27 |
|Figure 5.1 (a) schematic (b)compressions et expansions along the direction | |
| 28 |
| of sound. | |
| 29 |
+----------------------------------------------------------------------------+ |
| 30 |
|
| 31 |
Procedure |
| 32 |
---------- |
| 33 |
|
| 34 |
- Set frequency to resonant maximum by measuring the frequency response |
| 35 |
`5.1↑ <#sec:Resonance-frequency-of>`__ |
| 36 |
- Keep the Piezo facing the microphone, on the same axis |
| 37 |
- Enable measurement |
| 38 |
- Adjust the distance to make both the traces in Phase |
| 39 |
- Change the distance to make them 180 degree out of phase, that |
| 40 |
distance is half wave length. |
| 41 |
|
| 42 |
.. image:: pics/sound-velocity180-screen.png |
| 43 |
:width: 400px |
| 44 |
|
| 45 |
Discussion |
| 46 |
---------- |
| 47 |
|
| 48 |
At 3500 Hz, for a 2 cm change in distance the phase changed from 176 |
| 49 |
to |
| 50 |
102. Using the equation, :math:`v = f \times (360 \times \Delta D)/X`, |
| 51 |
:math:`v = 3500 \times (360 \times 2)/(176 102) = 34054~cm\cdot |
| 52 |
s^{ 1}`. It is important to keep the mic and the Piezo disc on the |
| 53 |
same axis, for accurate results. |