| 1 |
Half wave rectifier using PN junction |
| 2 |
===================================== |
| 3 |
|
| 4 |
A PN junction conducts only in one direction. Only one half of a pure AC |
| 5 |
signal can pass through a PN junction. This device is widely used for generating |
| 6 |
DC from AC. |
| 7 |
|
| 8 |
Objective |
| 9 |
--------- |
| 10 |
|
| 11 |
Learn the working of a PN junction diode as a rectifier. Use 1N4148 or |
| 12 |
1N4003. RC filtering to reduce the ripple (the AC component). |
| 13 |
|
| 14 |
Procedure |
| 15 |
--------- |
| 16 |
|
| 17 |
.. image:: schematics/halfwave.svg |
| 18 |
:width: 300px |
| 19 |
|
| 20 |
- Fix the diode on a bread board |
| 21 |
- Make connections and observe the output |
| 22 |
- Connect a :math:`1~k\Omega` load resistor, note the difference in amplitude |
| 23 |
|
| 24 |
The output is shown below. |
| 25 |
|
| 26 |
.. image:: pics/halfwave-screen.png |
| 27 |
:width: 400px |
| 28 |
|
| 29 |
- Connect a :math:`1 \mu F` capacitor, and see the filtering effect. |
| 30 |
- Try different values load resistors and filter capacitors |
| 31 |
|
| 32 |
The effect of the RC filter is shown below. |
| 33 |
|
| 34 |
.. image:: pics/halfwave-filter-screen.png |
| 35 |
:width: 400px |
| 36 |
|
| 37 |
Discussion |
| 38 |
---------- |
| 39 |
|
| 40 |
The negative half is removed by the diode as shown in figure. The output is a bit noisy |
| 41 |
and there is some reduction in the voltage. When you connect the load resistor, the |
| 42 |
output becomes clean and the voltage drop becomes around 0.7 volts, |
| 43 |
the voltage drop across a silicon diode. |
| 44 |
A load resistor is required for the proper operation of the circuit, it could be more than |
| 45 |
1kΩ but do NOT use very low values since our AC source can drive only up |
| 46 |
to 5 mA current. |
| 47 |
|
| 48 |
We can see that the capacitor charges up and then during the missing |
| 49 |
cycle it maintains the voltage. The remaining AC component is called the |
| 50 |
ripple in the DC. Can we use very large capacitance to reduce the ripple ? |
| 51 |
During what part of the cycle does current flow through the diode ? |
| 52 |
Amount of peak current is decided by what ? |
| 53 |
|
| 54 |
If you use a 1N400x diode without a load resistor, there is some voltage appearing at the output |
| 55 |
during the negative half also. This will vanish when load resistor is connected. Think of |
| 56 |
parasitic elements , like the capacitance of the PN juction. Why it is less for 1N4148. |
| 57 |
|
| 58 |
.. image:: pics/halfwave-capacitance-screen.png |
| 59 |
:width: 400px |