| 1 |
Acceleration due to gravity using Rod pendulum |
| 2 |
=============================================== |
| 3 |
|
| 4 |
Period of oscillations of a pendulum depends on it's length and the value of gravity. |
| 5 |
Period of oscillation of a uniform rod about one end is given by |
| 6 |
:math:`T = 2\pi\sqrt{2l/3g}`, where :math:`l` is the length and :math:`g` is the acceleration due to gravity. |
| 7 |
|
| 8 |
Objective |
| 9 |
--------- |
| 10 |
|
| 11 |
Measure the period of oscillations of a rod pendulum using a photo-transisor and |
| 12 |
LED arrangement. The pendulum (T-shaped, a knife edge attached to a 6mm |
| 13 |
dia rod) is made to swing between an LED and photo-transistor, connected |
| 14 |
to expEYES. The LED and photo-transistor are mounted on a U-shaped |
| 15 |
bracket as shown in figure. |
| 16 |
|
| 17 |
.. image:: schematics/rod-pendulum.svg |
| 18 |
:width: 400px |
| 19 |
.. image:: pics/rod-pend-LB.jpg |
| 20 |
:width: 200px |
| 21 |
|
| 22 |
Procedure |
| 23 |
--------- |
| 24 |
|
| 25 |
- Oscillate the pendulum and click on START |
| 26 |
- Repeat with different pendulum lengths. |
| 27 |
|
| 28 |
Discussion |
| 29 |
---------- |
| 30 |
|
| 31 |
The period of oscillation can be measured with an accuracy of 100 microseconds. |
| 32 |
However mainly there are two sources of error. The length is measured from the knife |
| 33 |
edge to the bottom and used in the formula. But there is a small mass projecting |
| 34 |
above the knife edge that is not included in the calculation. Also the |
| 35 |
calculations assume that the pendulum must be exactly vertical in the resting |
| 36 |
position, which has to be ensured. |