Debian Codegraph @

eyes17/helpFiles/hi/_sources/3.15.rst

raw
1 PNP Transistor Output characteristics (CE)
2 ===========================================
3
4 The basic working principle of a transistor is controlling a bigger current in circuit using a small current in another circuit. Being a three terminal device, one terminal has to be common for the two crcuits. The common emitter configuration
5 is very common in most of the applications. We can explore the working of the transistor by studying the relationships between various voltages at different terminals and currents through them.
6
7
8 Objective
9 ---------
10
11 Using a PNP transistor, plot the Collector voltage against the collector current
12 in a common emitter configuration. Repeat it for different base currennts. Collector current
13 is calculated from the voltage across the a 1K resistor, in the collector circuit.
14
15 Procedure
16 ---------
17
18 .. image:: schematics/pnp_ce_char.svg
19 :width: 300px
20
21 - Fix the transistor on a bread board and make the connections.
22 - Set base voltage to the 1 volt and press the START button.
23 - Repeat for different base currents, increment PV2 by 0.3 volt steps.
24
25 The resulting graphs are shown below. This experiments also can be done manually from
26 the oscilloscope GUI, by noting down the readings.
27
28 .. image:: pics/pnp-ce-char-screen.png
29 :width: 400px
30
31
32 Discussion
33 ----------
34
35 The characteristic curves for different base currents are shown in
36 figure. The collector current is obtained from the voltage difference
37 across the :math:`1~k\Omega` resistor.
38
39 The base current is set by setting the voltage at one end of the :math:`100~k\Omega`
40 resistor, the other end is connected to the transistor base. The value
41 of base current is calculated by,
42 :math:`I_b = (V_{PV2} V_{A2})/(100 \times 10^3) \times 10^6~\mu A`.
43 If A2 is not connected, the code assumes 0.6 volts at the base to
44 calculate the base current.