| 1 |
NPN Transistor Output characteristics (CE) |
| 2 |
=========================================== |
| 3 |
The basic working principle of a transistor is controlling a bigger current in circuit using a small current in another circuit. Being a three terminal device, one terminal has to be common for the two crcuits. The common emitter configuration |
| 4 |
is very common in most of the applications. We can explore the working of the transistor by studying the relationships between various voltages at different terminals and currents through them. |
| 5 |
|
| 6 |
|
| 7 |
Objective |
| 8 |
--------- |
| 9 |
|
| 10 |
Using an NPN transistor, plot the Collector voltage against the collector current |
| 11 |
in a common emitter configuration. Repeat it for different base currents. Collector current |
| 12 |
is calculated from the voltage across the a :math:`1~k\Omega` resistor, |
| 13 |
in the collector circuit. |
| 14 |
|
| 15 |
Procedure |
| 16 |
--------- |
| 17 |
|
| 18 |
.. image:: schematics/npn-ce-char.svg |
| 19 |
:width: 300px |
| 20 |
|
| 21 |
- Fix the transistor on a bread board and make the connections. |
| 22 |
- Set base voltage to 1 volt and press the START button. |
| 23 |
- Repeat for different base currents, increment PV2 by 0.3 volt steps. |
| 24 |
|
| 25 |
The resulting graphs are shown below. This experiments also can be done manually from |
| 26 |
the oscilloscope GUI, by noting down the readings. |
| 27 |
|
| 28 |
.. image:: pics/npn-ce-char-screen.png |
| 29 |
:width: 400px |
| 30 |
|
| 31 |
|
| 32 |
Discussion |
| 33 |
---------- |
| 34 |
|
| 35 |
The characteristic curves for different base currents are shown in |
| 36 |
figure. The collector current is obtained from the voltage difference |
| 37 |
across the :math:`1~k\Omega` resistor. |
| 38 |
|
| 39 |
The base current is set by setting the voltage at one end of the :math:`100~k\Omega` |
| 40 |
resistor, the other end is connected to the transistor base. The value |
| 41 |
of base current is calculated by, |
| 42 |
:math:`I_b = (V_{PV2} V_{A2})/(100 \times 10^3) \times 10^6~\mu A`. |
| 43 |
If A2 is not connected, the code assumes 0.6 volts at the base to |
| 44 |
calculate the base current. |