| 1 |
Non-inverting Amplifier |
| 2 |
======================== |
| 3 |
|
| 4 |
This experiment is very similar to the previous one, the inverting amplifier. |
| 5 |
|
| 6 |
Objective |
| 7 |
--------- |
| 8 |
|
| 9 |
Wire an non-inverting amplifier using an Op-Amp, like µA741 or OP07, and test it. |
| 10 |
|
| 11 |
Procedure |
| 12 |
--------- |
| 13 |
|
| 14 |
.. image:: schematics/opamp-noninv.svg |
| 15 |
:width: 300px |
| 16 |
|
| 17 |
- Make the connections on bread board as shown in the figure. |
| 18 |
- Set WG amplitude to 80 mV and frequency to 1000 Hz |
| 19 |
- Enable A1 and A2, and set ranges to 1V |
| 20 |
- Enable the amplitude and frequency displays of A1 and A2. |
| 21 |
- Make connections and calculate the voltage gain from the output |
| 22 |
- Change gain by changing the resistor values. |
| 23 |
|
| 24 |
The amplitude gain and and the phase difference can be observed from the output below. |
| 25 |
|
| 26 |
.. image:: pics/opamp-noninv-screen.png |
| 27 |
:width: 400px |
| 28 |
|
| 29 |
Discussion |
| 30 |
---------- |
| 31 |
|
| 32 |
Using expEYES, it is not possible to study the high frequency response. |
| 33 |
|