| 1 |
Transistor Amplifier CE |
| 2 |
======================= |
| 3 |
|
| 4 |
The experiment to draw the transistor characteristics can be modified to |
| 5 |
convert it into a common emitter amplifier. All we need to do is to make a |
| 6 |
potential divider network to reduce the amplitude of WG to a value less than 80 mV. |
| 7 |
This reduced output is connected to the base through a :math:`1 \mu F` capacitor. |
| 8 |
|
| 9 |
Objective |
| 10 |
--------- |
| 11 |
Demonstrates the amplifier action of an NPN transistor in the |
| 12 |
common emitter configuration. |
| 13 |
|
| 14 |
Procedure |
| 15 |
--------- |
| 16 |
|
| 17 |
.. image:: schematics/transistor-amplifier.svg |
| 18 |
:width: 300px |
| 19 |
|
| 20 |
- Fix the transistor on bread board and make connection as shown in the figure. |
| 21 |
- Set base voltage to the 1 volt and START. |
| 22 |
- Set WG amplitude to 80mV. |
| 23 |
- Enable A1 and A2 |
| 24 |
- Use the slider to change base voltage to observe the shift in operating point. |
| 25 |
|
| 26 |
The output is shown below. It can be seen that the input and output signals are 180 degree out of phase. |
| 27 |
|
| 28 |
.. image:: pics/transistor-amplifier-screen.png |
| 29 |
:width: 400px |
| 30 |
|
| 31 |
|
| 32 |
Discussion |
| 33 |
---------- |
| 34 |
|
| 35 |
The base current is set the PV2 voltage applied via the :math:`100~k\Omega` |
| 36 |
resistor. This sets DC operating point of the circuit.Choose this to get |
| 37 |
minimum distortion in the output. |