| 1 |
// SPDX-License-Identifier: ISC |
| 2 |
/* |
| 3 |
* Device Tree include file for Intel reference designs for the |
| 4 |
* XScale Network Processors in the IXP 4xx series. Common device |
| 5 |
* set-up for IXDP425, IXCDP1100, KIXRP435 and IXDP465. |
| 6 |
*/ |
| 7 |
|
| 8 |
/ { |
| 9 |
memory@0 { |
| 10 |
/* |
| 11 |
* The board supports up to 256 MB of memory. Here we put in |
| 12 |
* 64 MB and this may be modified by the boot loader. |
| 13 |
*/ |
| 14 |
device_type = "memory"; |
| 15 |
reg = <0x00000000 0x4000000>; |
| 16 |
}; |
| 17 |
|
| 18 |
chosen { |
| 19 |
bootargs = "console=ttyS0,115200n8"; |
| 20 |
stdout-path = "uart0:115200n8"; |
| 21 |
}; |
| 22 |
|
| 23 |
aliases { |
| 24 |
serial0 = &uart0; |
| 25 |
}; |
| 26 |
|
| 27 |
i2c { |
| 28 |
compatible = "i2c-gpio"; |
| 29 |
sda-gpios = <&gpio0 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>; |
| 30 |
scl-gpios = <&gpio0 6 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>; |
| 31 |
#address-cells = <1>; |
| 32 |
#size-cells = <0>; |
| 33 |
|
| 34 |
eeprom@50 { |
| 35 |
/* |
| 36 |
* Philips PCF8582C-2T/03 512byte I2C EEPROM |
| 37 |
* should behave like an Atmel 24c04. |
| 38 |
*/ |
| 39 |
compatible = "atmel,24c04"; |
| 40 |
reg = <0x50>; |
| 41 |
pagesize = <16>; |
| 42 |
size = <512>; |
| 43 |
read-only; |
| 44 |
}; |
| 45 |
}; |
| 46 |
|
| 47 |
soc { |
| 48 |
bus@c4000000 { |
| 49 |
/* Flash memory defined per-variant */ |
| 50 |
nand-controller@3,0 { |
| 51 |
/* Some designs have a NAND on CS3 enable it here if present */ |
| 52 |
status = "disabled"; |
| 53 |
|
| 54 |
/* |
| 55 |
* gen_nand needs to be extended and documented to get |
| 56 |
* command byte = 1 and address byte = 2 from the device |
| 57 |
* tree. |
| 58 |
*/ |
| 59 |
compatible = "gen_nand"; |
| 60 |
|
| 61 |
/* Expansion bus set-up */ |
| 62 |
intel,ixp4xx-eb-t1 = <0>; |
| 63 |
intel,ixp4xx-eb-t2 = <0>; |
| 64 |
intel,ixp4xx-eb-t3 = <1>; // 1 cycle extra strobe phase |
| 65 |
intel,ixp4xx-eb-t4 = <0>; |
| 66 |
intel,ixp4xx-eb-t5 = <0>; |
| 67 |
intel,ixp4xx-eb-cycle-type = <0>; // Intel cycle type |
| 68 |
intel,ixp4xx-eb-byte-access-on-halfword = <0>; |
| 69 |
intel,ixp4xx-eb-mux-address-and-data = <0>; |
| 70 |
intel,ixp4xx-eb-ahb-split-transfers = <0>; |
| 71 |
intel,ixp4xx-eb-write-enable = <1>; |
| 72 |
intel,ixp4xx-eb-byte-access = <1>; |
| 73 |
|
| 74 |
/* 512 bytes memory window */ |
| 75 |
reg = <3 0x00000000 0x200>; |
| 76 |
nand-on-flash-bbt; |
| 77 |
nand-ecc-mode = "soft_bch"; |
| 78 |
nand-ecc-step-size = <512>; |
| 79 |
nand-ecc-strength = <4>; |
| 80 |
nce-gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>; /* NCE */ |
| 81 |
|
| 82 |
label = "ixp400 NAND"; |
| 83 |
|
| 84 |
partitions { |
| 85 |
compatible = "fixed-partitions"; |
| 86 |
#address-cells = <1>; |
| 87 |
#size-cells = <1>; |
| 88 |
|
| 89 |
fs@0 { |
| 90 |
label = "ixp400 NAND FS 0"; |
| 91 |
reg = <0x0 0x800000>; |
| 92 |
}; |
| 93 |
fs@800000 { |
| 94 |
label = "ixp400 NAND FS 1"; |
| 95 |
reg = <0x800000 0x0>; |
| 96 |
}; |
| 97 |
}; |
| 98 |
}; |
| 99 |
}; |
| 100 |
|
| 101 |
pci@c0000000 { |
| 102 |
status = "okay"; |
| 103 |
|
| 104 |
/* |
| 105 |
* Taken from IXDP425 PCI boardfile. |
| 106 |
* PCI slots on the BIXMB425BD base card. |
| 107 |
* We have up to 4 slots (IDSEL) with 4 swizzled IRQs. |
| 108 |
*/ |
| 109 |
#interrupt-cells = <1>; |
| 110 |
interrupt-map-mask = <0xf800 0 0 7>; |
| 111 |
interrupt-map = |
| 112 |
/* IDSEL 1 */ |
| 113 |
<0x0800 0 0 1 &gpio0 11 IRQ_TYPE_LEVEL_LOW>, /* INT A on slot 1 is irq 11 */ |
| 114 |
<0x0800 0 0 2 &gpio0 10 IRQ_TYPE_LEVEL_LOW>, /* INT B on slot 1 is irq 10 */ |
| 115 |
<0x0800 0 0 3 &gpio0 9 IRQ_TYPE_LEVEL_LOW>, /* INT C on slot 1 is irq 9 */ |
| 116 |
<0x0800 0 0 4 &gpio0 8 IRQ_TYPE_LEVEL_LOW>, /* INT D on slot 1 is irq 8 */ |
| 117 |
/* IDSEL 2 */ |
| 118 |
<0x1000 0 0 1 &gpio0 10 IRQ_TYPE_LEVEL_LOW>, /* INT A on slot 2 is irq 10 */ |
| 119 |
<0x1000 0 0 2 &gpio0 9 IRQ_TYPE_LEVEL_LOW>, /* INT B on slot 2 is irq 9 */ |
| 120 |
<0x1000 0 0 3 &gpio0 8 IRQ_TYPE_LEVEL_LOW>, /* INT C on slot 2 is irq 8 */ |
| 121 |
<0x1000 0 0 4 &gpio0 11 IRQ_TYPE_LEVEL_LOW>, /* INT D on slot 2 is irq 11 */ |
| 122 |
/* IDSEL 3 */ |
| 123 |
<0x1800 0 0 1 &gpio0 9 IRQ_TYPE_LEVEL_LOW>, /* INT A on slot 3 is irq 9 */ |
| 124 |
<0x1800 0 0 2 &gpio0 8 IRQ_TYPE_LEVEL_LOW>, /* INT B on slot 3 is irq 8 */ |
| 125 |
<0x1800 0 0 3 &gpio0 11 IRQ_TYPE_LEVEL_LOW>, /* INT C on slot 3 is irq 11 */ |
| 126 |
<0x1800 0 0 4 &gpio0 10 IRQ_TYPE_LEVEL_LOW>, /* INT D on slot 3 is irq 10 */ |
| 127 |
/* IDSEL 4 */ |
| 128 |
<0x2000 0 0 1 &gpio0 8 IRQ_TYPE_LEVEL_LOW>, /* INT A on slot 4 is irq 8 */ |
| 129 |
<0x2000 0 0 2 &gpio0 11 IRQ_TYPE_LEVEL_LOW>, /* INT B on slot 4 is irq 11 */ |
| 130 |
<0x2000 0 0 3 &gpio0 10 IRQ_TYPE_LEVEL_LOW>, /* INT C on slot 4 is irq 10 */ |
| 131 |
<0x2000 0 0 4 &gpio0 9 IRQ_TYPE_LEVEL_LOW>; /* INT D on slot 4 is irq 9 */ |
| 132 |
}; |
| 133 |
}; |
| 134 |
}; |