| 1 |
Measuring Resistance |
| 2 |
==================== |
| 3 |
|
| 4 |
Resistance is generally measured using a multimeter. ExpEYES provides a limited facility |
| 5 |
to do this, using the SEN terminal. SEN is actually a voltage measurement terminal, with |
| 6 |
a :math:`5.1k~\Omega` resistor connected to :math:`3.3V` internally. The internal :math:`5.1k~\Omega` |
| 7 |
and the external resistor connected to SEN forms a series combination. By knowing the voltage across both |
| 8 |
and the value of one resistance, we can calculate the other using Ohm's law. The drawback of this method |
| 9 |
is that the accuracy is poor when the external resistance differs widely from :math:`5.1k~\Omega`. |
| 10 |
A resonable range is from :math:`100~\Omega` to :math:`100~k\Omega`. |
| 11 |
|
| 12 |
Objective |
| 13 |
--------- |
| 14 |
|
| 15 |
Measure resistance using the **SEN** terminal. |
| 16 |
|
| 17 |
.. image:: schematics/res-measure.svg |
| 18 |
:width: 300px |
| 19 |
|
| 20 |
Procedure |
| 21 |
--------- |
| 22 |
|
| 23 |
- Connect the resistor between SEN and any Ground terminal. |
| 24 |
- Observe the value shown on the top right side of the GUI. |
| 25 |
- Repeat with different resistors |