| 1 |
.PS |
| 2 |
# Spec555.m4 |
| 3 |
# https://tex.stackexchange.com/questions/64801/display-ics-with-circuitikz?rq=1 |
| 4 |
log_init |
| 5 |
|
| 6 |
define(`spec555',`[ Chip: box wid 8*lg_pinsep ht 10*lg_pinsep fill_(0.9) |
| 7 |
svg_font(sans-serif,8bp__) |
| 8 |
P1: 3/4<Chip.sw,Chip.se>; {"1" below rjust at P1}; "GND" above at P1 |
| 9 |
P5: Chip.s; {"5" below rjust at P5}; "CTRL" above at P5 |
| 10 |
P2: 1/8<Chip.sw,Chip.nw>; {"2" above rjust at P2}; "TRG" ljust at P2 |
| 11 |
P6: 3/8<Chip.sw,Chip.nw>; {"6" above rjust at P6}; "THR" ljust at P6 |
| 12 |
P7: 7/8<Chip.sw,Chip.nw>; {"7" above rjust at P7}; "DIS" ljust at P7 |
| 13 |
P3: Chip.e; {"3" above ljust at P3}; "OUT" rjust at P3 |
| 14 |
P4: 3/4<Chip.nw,Chip.ne>; {"4" above rjust at P4}; "svg_emsp`'RESET" below \ |
| 15 |
at P4 |
| 16 |
P8: Chip.n; {"8" above rjust at P8}; "Vcc" below at P8 |
| 17 |
"NE-555" at Chip.c "TIMER" |
| 18 |
command "</g>" |
| 19 |
line left dimen_ from P7; X:dot |
| 20 |
{ R1:resistor(up_ P7.y-P6.y); rlabel(,68 k`'svg_ohm); dot } |
| 21 |
R2:resistor(down_ P7.y-P6.y); llabel(,68 k`'svg_ohm); dot; {line to P6} |
| 22 |
line to (Here,P2); SW: dot; {line to P2} |
| 23 |
line from P8 to (P8,R1.end); dot ]') |
| 24 |
|
| 25 |
svg_font(sans-serif,10bp__) |
| 26 |
T1: spec555; "U1" at T1.Chip.nw above ljust |
| 27 |
T2: spec555 with .Chip.w at T1.Chip.e+(2.5*dimen_,0) |
| 28 |
"U2" at T2.Chip.nw above ljust |
| 29 |
{line left_ dimen_/2 from (T1.X,T1.P7); diode(down_ T1.P7.y-T1.P6.y) |
| 30 |
{"D1" wid 15bp__ rjust at last [].w "1N4148" rjust wid 36bp__} |
| 31 |
line to (T1.X,Here); dot} |
| 32 |
capacitor(down_ elen_*1.2 from T1.SW,E+); llabel(,10 uF); dot |
| 33 |
dot(at Here-(dimen_/2,0),,1); G: dot(,,1); "GND" rjust at G.w |
| 34 |
capacitor(from T1.P5 to (T1.P5,G),E+); rlabel(,0.01 nF); dot |
| 35 |
line from T1.P1 to (T1.P1,G); dot |
| 36 |
Vcc: dot(at (G,T1.R1.end),,1); "Vcc" wid 0.3 rjust at Vcc.w |
| 37 |
dot(at (T1.P4,Vcc)); line to T1.P4 |
| 38 |
line right_ dimen_/2 from T1.P3; |
| 39 |
R3: resistor(down_ to (Here,T2.s-(0,dimen_/4))); llabel(,10 k`'svg_ohm) |
| 40 |
line to (T2.P5,Here) then to T2.P5 |
| 41 |
dot(at (T2.X,G)); ground |
| 42 |
reversed(`capacitor',up_ to (Here,T2.P5),E+); rlabel(,100 nF) |
| 43 |
line to (Here,T2.P2) |
| 44 |
line from T2.P1 to (T2.P1,G); dot |
| 45 |
line from T2.P4 to (T2.P4,Vcc) then to Vcc chop 0 chop dotrad_ |
| 46 |
dot(at (T2.X,T2.R1.end)+(0,dimen_/2),,1); {line to T2.R1.end chop dotrad_} |
| 47 |
"+5 V to +15V" at last [].n above |
| 48 |
capacitor(right_ dimen_ from T2.P3,C); llabel(," 100 uF") |
| 49 |
Pot1: potentiometer(down_ (Here.y-G.y)/2) with .Start at Here |
| 50 |
"Rx" wid 0.2 at Pot1.T1 ljust |
| 51 |
Sp: speaker(R,,,fill_(0.9)) with .In5 at Pot1.End |
| 52 |
"1" above rjust at Sp.In5; "2" below rjust at Sp.In7 |
| 53 |
"E1" at Sp.In2 rjust "Speaker" rjust |
| 54 |
line from Sp.In7 to (Sp.In7,G) then to G chop 0 chop dotrad_ |
| 55 |
command "</g>" |
| 56 |
|
| 57 |
.PE |