| 1 |
<h2 id="schematic">Schematic</h2> |
| 2 |
<hr> |
| 3 |
<p><img src="images/pendulum-velocity.png" alt=""></p> |
| 4 |
<p>A pendulum executes simple harmonic motion. If the anglular displacement |
| 5 |
is plotted against time, we get a sine wave. But angle encoders are costly, |
| 6 |
we can use a DC motor as angular velocity encoder, the induced voltage is |
| 7 |
proportional to the instantaneous angular velocity.</p> |
| 8 |
<h2 id="instructions">Instructions</h2> |
| 9 |
<hr> |
| 10 |
<ul> |
| 11 |
<li>The pendulum is attached to the axis of the motor.</li> |
| 12 |
<li>The induced DC voltage is proportional to the angular velocity.</li> |
| 13 |
<li>The signal is measured by A3. The 100 Ohm resistor between Rg and Ground, |
| 14 |
sets an amplificaion factor of 1 + 10000/100 = 101, it is required since the |
| 15 |
induced voltage is small.</li> |
| 16 |
<li>Oscillate the pendulum and press <strong>START</strong> button to record the data.</li> |
| 17 |
<li>If the signal is noisy, try rotating the whole body of the motor by several |
| 18 |
degrees and try again.</li> |
| 19 |
</ul> |