| 1 |
<h2 id="schematic">Schematic</h2> |
| 2 |
<hr> |
| 3 |
<p><img src="images/filterCircuit.png" alt=""></p> |
| 4 |
<h2 id="instructions">Instructions</h2> |
| 5 |
<hr> |
| 6 |
<ul> |
| 7 |
<li>Make connections as shown. The picture shows an LC filter with a load resistor.</li> |
| 8 |
<li>You may use any other type of filter. </li> |
| 9 |
<li>We apply a sine wave of a given frequency at the input of the filter and the same is measured by A1.</li> |
| 10 |
<li>The output of the filter is measured by A2 and the ratio of amplitudes (the gain) is calculated.</li> |
| 11 |
<li>This process is repeated for a range of frequencies and gain is plotted as a function of frequency.</li> |
| 12 |
<li>To start with try C = 1uF, L = 1mH, R = 1000 Ohm, Calculate f0 = 1/(2*pi*sqrt(L*C))</li> |
| 13 |
<li>Try parallel and series LC combinations.</li> |
| 14 |
</ul> |