| 1 |
<h2 id="schematic">Schematic</h2> |
| 2 |
<hr> |
| 3 |
<p><img src="images/fullwave.png" alt=""></p> |
| 4 |
<ul> |
| 5 |
<li>Full wave rectifiers are generally made using the outputs of a transformer with |
| 6 |
center tap.</li> |
| 7 |
<li>The voltage waveform at both ends of the transformer is 180 degree out of phase. That means each |
| 8 |
diode conducts during the alternate half cycles.</li> |
| 9 |
<li>In this case the 180 degree out of phase waveforms are provided by WG and WG bar.</li> |
| 10 |
</ul> |
| 11 |
<h2 id="instructions">Instructions</h2> |
| 12 |
<hr> |
| 13 |
<ul> |
| 14 |
<li>Connect the diodes, without resistor, and observe the rectified output.</li> |
| 15 |
<li>Add the resitor and see the change in the amplitude.</li> |
| 16 |
<li>Connect capacitor to see the effect of the filter. Change Rc values and repeat. |
| 17 |
<strong>(Do not use R below 500 Ohm)</strong></li> |
| 18 |
</ul> |