| 1 |
<h2 id="schematic">Schematic</h2> |
| 2 |
<hr> |
| 3 |
<p><img src="images/opamp-int.png" alt=""></p> |
| 4 |
<ul> |
| 5 |
<li>Op-Amps can be used for making active integrators.</li> |
| 6 |
</ul> |
| 7 |
<h2 id="instructions">Instructions</h2> |
| 8 |
<hr> |
| 9 |
<ul> |
| 10 |
<li><p>Make a circuit as shown in the figure.</p></li> |
| 11 |
<li><p>Without the capacitor, it is an inverting amplifier with gain -2.2.</p></li> |
| 12 |
<li><p>Apply a triangular wave of 1 volt amplitude at the input and watch the output.</p></li> |
| 13 |
<li><p>We cannot have high gains because the power supply is only +/-6 volts.</p></li> |
| 14 |
<li><p>Add a 0.1 uF capacitor and see the change in the output. </p></li> |
| 15 |
<li><p>Observe the same at different frequencies. </p></li> |
| 16 |
<li><p>What happens when you integrate the Sine wave ?</p></li> |
| 17 |
</ul> |