Debian Codegraph @

upstream/debian-unstable/man8/plipconfig.8

raw
1 .TH PLIPCONFIG 8 "2008\-10\-03" "net\-tools" "Linux System Administrator's Manual"
2 .SH NAME
3 plipconfig \- fine tune PLIP device parameters
4 .SH SYNOPSIS
5 .B plipconfig interface
6 .RB [ nibble
7 .IR NN ]
8 .RB [ trigger
9 .IR NN ]
10 .br
11 .B plipconfig
12 .RB [ \-V ]
13 .RB [ \-\-version ]
14 .RB [ \-h ]
15 .RB [ \-\-help ]
16 .SH DESCRIPTION
17 .B Plipconfig
18 is used to (hopefully) improve PLIP performance by changing the default
19 timing parameters used by the PLIP protocol. Results are dependent on
20 the parallel port hardware, cable, and the CPU speed of each machine
21 on each end of the PLIP link.
22 .LP
23 If the single
24 .B interface
25 argument is given,
26 .B plipconfig
27 displays the status of the given interface
28 only. Otherwise, it will try to set the options.
29 .SH OPTIONS
30 .TP
31 .B "nibble NN"
32 Sets the nibble wait value in microseconds. Default is 3000.
33 .TP
34 .B "trigger NN"
35 Sets the trigger wait value in microseconds. Default is 500.
36 .LP
37 PLIP speed can in some cases be improved by lowering the default values.
38 Values which are too low may cause excess use of CPU, poor interrupt
39 response time resulting in serial ports dropping characters, or in dropping
40 of PLIP packets. Changing the plip MTU can also affect PLIP speed.
41 .SH NOTE
42 If you get no response it is far more likely the irq is wrong and needs
43 setting with ifconfig. The few cases where the default parameters will
44 be too fast are those using very long cables. Something you should
45 never do as the parallel port is not specified or designed for driving
46 long cable runs.
47 .SH SEE ALSO
48 .BR ifconfig (8)
49 .SH BUGS
50 Non.
51 .SH AUTHOR
52 John Paul Morrison, <[email protected]>, <[email protected]>
53