| 1 |
// SPDX-License-Identifier: GPL-2.0 |
| 2 |
/* |
| 3 |
* Renesas Technology Corp. SH7786 Urquell Support. |
| 4 |
* |
| 5 |
* Copyright (C) 2008 Kuninori Morimoto <[email protected]> |
| 6 |
* Copyright (C) 2009, 2010 Paul Mundt |
| 7 |
* |
| 8 |
* Based on board-sh7785lcr.c |
| 9 |
* Copyright (C) 2008 Yoshihiro Shimoda |
| 10 |
*/ |
| 11 |
#include <linux/init.h> |
| 12 |
#include <linux/platform_device.h> |
| 13 |
#include <linux/fb.h> |
| 14 |
#include <linux/smc91x.h> |
| 15 |
#include <linux/mtd/physmap.h> |
| 16 |
#include <linux/delay.h> |
| 17 |
#include <linux/gpio.h> |
| 18 |
#include <linux/irq.h> |
| 19 |
#include <linux/clk.h> |
| 20 |
#include <linux/sh_intc.h> |
| 21 |
#include <mach/urquell.h> |
| 22 |
#include <cpu/sh7786.h> |
| 23 |
#include <asm/heartbeat.h> |
| 24 |
#include <linux/sizes.h> |
| 25 |
#include <asm/smp-ops.h> |
| 26 |
|
| 27 |
/* |
| 28 |
* bit 1234 5678 |
| 29 |
*---------------------------- |
| 30 |
* SW1 0101 0010 -> Pck 33MHz version |
| 31 |
* (1101 0010) Pck 66MHz version |
| 32 |
* SW2 0x1x xxxx -> little endian |
| 33 |
* 29bit mode |
| 34 |
* SW47 0001 1000 -> CS0 : on-board flash |
| 35 |
* CS1 : SRAM, registers, LAN, PCMCIA |
| 36 |
* 38400 bps for SCIF1 |
| 37 |
* |
| 38 |
* Address |
| 39 |
* 0x00000000 - 0x04000000 (CS0) Nor Flash |
| 40 |
* 0x04000000 - 0x04200000 (CS1) SRAM |
| 41 |
* 0x05000000 - 0x05800000 (CS1) on board register |
| 42 |
* 0x05800000 - 0x06000000 (CS1) LAN91C111 |
| 43 |
* 0x06000000 - 0x06400000 (CS1) PCMCIA |
| 44 |
* 0x08000000 - 0x10000000 (CS2-CS3) DDR3 |
| 45 |
* 0x10000000 - 0x14000000 (CS4) PCIe |
| 46 |
* 0x14000000 - 0x14800000 (CS5) Core0 LRAM/URAM |
| 47 |
* 0x14800000 - 0x15000000 (CS5) Core1 LRAM/URAM |
| 48 |
* 0x18000000 - 0x1C000000 (CS6) ATA/NAND-Flash |
| 49 |
* 0x1C000000 - (CS7) SH7786 Control register |
| 50 |
*/ |
| 51 |
|
| 52 |
/* HeartBeat */ |
| 53 |
static struct resource heartbeat_resource = { |
| 54 |
.start = BOARDREG(SLEDR), |
| 55 |
.end = BOARDREG(SLEDR), |
| 56 |
.flags = IORESOURCE_MEM | IORESOURCE_MEM_16BIT, |
| 57 |
}; |
| 58 |
|
| 59 |
static struct platform_device heartbeat_device = { |
| 60 |
.name = "heartbeat", |
| 61 |
.id = -1, |
| 62 |
.num_resources = 1, |
| 63 |
.resource = &heartbeat_resource, |
| 64 |
}; |
| 65 |
|
| 66 |
/* LAN91C111 */ |
| 67 |
static struct smc91x_platdata smc91x_info = { |
| 68 |
.flags = SMC91X_USE_16BIT | SMC91X_NOWAIT, |
| 69 |
}; |
| 70 |
|
| 71 |
static struct resource smc91x_eth_resources[] = { |
| 72 |
[0] = { |
| 73 |
.name = "SMC91C111" , |
| 74 |
.start = 0x05800300, |
| 75 |
.end = 0x0580030f, |
| 76 |
.flags = IORESOURCE_MEM, |
| 77 |
}, |
| 78 |
[1] = { |
| 79 |
.start = evt2irq(0x360), |
| 80 |
.flags = IORESOURCE_IRQ, |
| 81 |
}, |
| 82 |
}; |
| 83 |
|
| 84 |
static struct platform_device smc91x_eth_device = { |
| 85 |
.name = "smc91x", |
| 86 |
.num_resources = ARRAY_SIZE(smc91x_eth_resources), |
| 87 |
.resource = smc91x_eth_resources, |
| 88 |
.dev = { |
| 89 |
.platform_data = &smc91x_info, |
| 90 |
}, |
| 91 |
}; |
| 92 |
|
| 93 |
/* Nor Flash */ |
| 94 |
static struct mtd_partition nor_flash_partitions[] = { |
| 95 |
{ |
| 96 |
.name = "loader", |
| 97 |
.offset = 0x00000000, |
| 98 |
.size = SZ_512K, |
| 99 |
.mask_flags = MTD_WRITEABLE, /* Read-only */ |
| 100 |
}, |
| 101 |
{ |
| 102 |
.name = "bootenv", |
| 103 |
.offset = MTDPART_OFS_APPEND, |
| 104 |
.size = SZ_512K, |
| 105 |
.mask_flags = MTD_WRITEABLE, /* Read-only */ |
| 106 |
}, |
| 107 |
{ |
| 108 |
.name = "kernel", |
| 109 |
.offset = MTDPART_OFS_APPEND, |
| 110 |
.size = SZ_4M, |
| 111 |
}, |
| 112 |
{ |
| 113 |
.name = "data", |
| 114 |
.offset = MTDPART_OFS_APPEND, |
| 115 |
.size = MTDPART_SIZ_FULL, |
| 116 |
}, |
| 117 |
}; |
| 118 |
|
| 119 |
static struct physmap_flash_data nor_flash_data = { |
| 120 |
.width = 2, |
| 121 |
.parts = nor_flash_partitions, |
| 122 |
.nr_parts = ARRAY_SIZE(nor_flash_partitions), |
| 123 |
}; |
| 124 |
|
| 125 |
static struct resource nor_flash_resources[] = { |
| 126 |
[0] = { |
| 127 |
.start = NOR_FLASH_ADDR, |
| 128 |
.end = NOR_FLASH_ADDR + NOR_FLASH_SIZE - 1, |
| 129 |
.flags = IORESOURCE_MEM, |
| 130 |
} |
| 131 |
}; |
| 132 |
|
| 133 |
static struct platform_device nor_flash_device = { |
| 134 |
.name = "physmap-flash", |
| 135 |
.dev = { |
| 136 |
.platform_data = &nor_flash_data, |
| 137 |
}, |
| 138 |
.num_resources = ARRAY_SIZE(nor_flash_resources), |
| 139 |
.resource = nor_flash_resources, |
| 140 |
}; |
| 141 |
|
| 142 |
static struct platform_device *urquell_devices[] __initdata = { |
| 143 |
&heartbeat_device, |
| 144 |
&smc91x_eth_device, |
| 145 |
&nor_flash_device, |
| 146 |
}; |
| 147 |
|
| 148 |
static int __init urquell_devices_setup(void) |
| 149 |
{ |
| 150 |
/* USB */ |
| 151 |
gpio_request(GPIO_FN_USB_OVC0, NULL); |
| 152 |
gpio_request(GPIO_FN_USB_PENC0, NULL); |
| 153 |
|
| 154 |
/* enable LAN */ |
| 155 |
__raw_writew(__raw_readw(UBOARDREG(IRL2MSKR)) & ~0x00000001, |
| 156 |
UBOARDREG(IRL2MSKR)); |
| 157 |
|
| 158 |
return platform_add_devices(urquell_devices, |
| 159 |
ARRAY_SIZE(urquell_devices)); |
| 160 |
} |
| 161 |
device_initcall(urquell_devices_setup); |
| 162 |
|
| 163 |
static void urquell_power_off(void) |
| 164 |
{ |
| 165 |
__raw_writew(0xa5a5, UBOARDREG(SRSTR)); |
| 166 |
} |
| 167 |
|
| 168 |
static void __init urquell_init_irq(void) |
| 169 |
{ |
| 170 |
plat_irq_setup_pins(IRQ_MODE_IRL3210_MASK); |
| 171 |
} |
| 172 |
|
| 173 |
static int urquell_mode_pins(void) |
| 174 |
{ |
| 175 |
return __raw_readw(UBOARDREG(MDSWMR)); |
| 176 |
} |
| 177 |
|
| 178 |
static int urquell_clk_init(void) |
| 179 |
{ |
| 180 |
struct clk *clk; |
| 181 |
int ret; |
| 182 |
|
| 183 |
/* |
| 184 |
* Only handle the EXTAL case, anyone interfacing a crystal |
| 185 |
* resonator will need to provide their own input clock. |
| 186 |
*/ |
| 187 |
if (test_mode_pin(MODE_PIN9)) |
| 188 |
return -EINVAL; |
| 189 |
|
| 190 |
clk = clk_get(NULL, "extal"); |
| 191 |
if (IS_ERR(clk)) |
| 192 |
return PTR_ERR(clk); |
| 193 |
ret = clk_set_rate(clk, 33333333); |
| 194 |
clk_put(clk); |
| 195 |
|
| 196 |
return ret; |
| 197 |
} |
| 198 |
|
| 199 |
/* Initialize the board */ |
| 200 |
static void __init urquell_setup(char **cmdline_p) |
| 201 |
{ |
| 202 |
printk(KERN_INFO "Renesas Technology Corp. Urquell support.\n"); |
| 203 |
|
| 204 |
pm_power_off = urquell_power_off; |
| 205 |
|
| 206 |
register_smp_ops(&shx3_smp_ops); |
| 207 |
} |
| 208 |
|
| 209 |
/* |
| 210 |
* The Machine Vector |
| 211 |
*/ |
| 212 |
static struct sh_machine_vector mv_urquell __initmv = { |
| 213 |
.mv_name = "Urquell", |
| 214 |
.mv_setup = urquell_setup, |
| 215 |
.mv_init_irq = urquell_init_irq, |
| 216 |
.mv_mode_pins = urquell_mode_pins, |
| 217 |
.mv_clk_init = urquell_clk_init, |
| 218 |
}; |