| 1 |
# SPDX-License-Identifier: GPL-2.0 |
| 2 |
|
| 3 |
config SH_STANDARD_BIOS |
| 4 |
bool "Use LinuxSH standard BIOS" |
| 5 |
help |
| 6 |
Say Y here if your target has the gdb-sh-stub |
| 7 |
package from www.m17n.org (or any conforming standard LinuxSH BIOS) |
| 8 |
in FLASH or EPROM. The kernel will use standard BIOS calls during |
| 9 |
boot for various housekeeping tasks (including calls to read and |
| 10 |
write characters to a system console, get a MAC address from an |
| 11 |
on-board Ethernet interface, and shut down the hardware). Note this |
| 12 |
does not work with machines with an existing operating system in |
| 13 |
mask ROM and no flash (WindowsCE machines fall in this category). |
| 14 |
If unsure, say N. |
| 15 |
|
| 16 |
config STACK_DEBUG |
| 17 |
bool "Check for stack overflows" |
| 18 |
depends on DEBUG_KERNEL && PRINTK |
| 19 |
help |
| 20 |
This option will cause messages to be printed if free stack space |
| 21 |
drops below a certain limit. Saying Y here will add overhead to |
| 22 |
every function call and will therefore incur a major |
| 23 |
performance hit. Most users should say N. |
| 24 |
|
| 25 |
config EARLY_PRINTK |
| 26 |
bool "Early printk" |
| 27 |
depends on SH_STANDARD_BIOS |
| 28 |
help |
| 29 |
Say Y here to redirect kernel printk messages to the serial port |
| 30 |
used by the SH-IPL bootloader, starting very early in the boot |
| 31 |
process and ending when the kernel's serial console is initialised. |
| 32 |
This option is only useful while porting the kernel to a new machine, |
| 33 |
when the kernel may crash or hang before the serial console is |
| 34 |
initialised. If unsure, say N. |
| 35 |
|
| 36 |
config 4KSTACKS |
| 37 |
bool "Use 4Kb for kernel stacks instead of 8Kb" |
| 38 |
depends on DEBUG_KERNEL && (MMU || BROKEN) && !PAGE_SIZE_64KB |
| 39 |
help |
| 40 |
If you say Y here the kernel will use a 4Kb stacksize for the |
| 41 |
kernel stack attached to each process/thread. This facilitates |
| 42 |
running more threads on a system and also reduces the pressure |
| 43 |
on the VM subsystem for higher order allocations. This option |
| 44 |
will also use IRQ stacks to compensate for the reduced stackspace. |
| 45 |
|
| 46 |
config IRQSTACKS |
| 47 |
bool "Use separate kernel stacks when processing interrupts" |
| 48 |
depends on DEBUG_KERNEL && BROKEN |
| 49 |
help |
| 50 |
If you say Y here the kernel will use separate kernel stacks |
| 51 |
for handling hard and soft interrupts. This can help avoid |
| 52 |
overflowing the process kernel stacks. |
| 53 |
|
| 54 |
config DUMP_CODE |
| 55 |
bool "Show disassembly of nearby code in register dumps" |
| 56 |
depends on DEBUG_KERNEL |
| 57 |
default y if DEBUG_BUGVERBOSE |
| 58 |
default n |
| 59 |
help |
| 60 |
This prints out a code trace of the instructions leading up to |
| 61 |
the faulting instruction as a debugging aid. As this does grow |
| 62 |
the kernel in size a bit, most users will want to say N here. |
| 63 |
|
| 64 |
Those looking for more verbose debugging output should say Y. |
| 65 |
|
| 66 |
config DWARF_UNWINDER |
| 67 |
bool "Enable the DWARF unwinder for stacktraces" |
| 68 |
depends on DEBUG_KERNEL |
| 69 |
select FRAME_POINTER |
| 70 |
default n |
| 71 |
help |
| 72 |
Enabling this option will make stacktraces more accurate, at |
| 73 |
the cost of an increase in overall kernel size. |
| 74 |
|
| 75 |
config SH_NO_BSS_INIT |
| 76 |
bool "Avoid zeroing BSS (to speed-up startup on suitable platforms)" |
| 77 |
depends on DEBUG_KERNEL |
| 78 |
default n |
| 79 |
help |
| 80 |
If running in painfully slow environments, such as an RTL |
| 81 |
simulation or from remote memory via SHdebug, where the memory |
| 82 |
can already be guaranteed to ber zeroed on boot, say Y. |
| 83 |
|
| 84 |
For all other cases, say N. If this option seems perplexing, or |
| 85 |
you aren't sure, say N. |
| 86 |
|
| 87 |
config MCOUNT |
| 88 |
def_bool y |
| 89 |
depends on STACK_DEBUG || FUNCTION_TRACER |