| 1 |
/* Generic NS8390 register definitions. */ |
| 2 |
/* This file is part of Donald Becker's 8390 drivers, and is distributed |
| 3 |
under the same license. Auto-loading of 8390.o only in v2.2 - Paul G. |
| 4 |
Some of these names and comments originated from the Crynwr |
| 5 |
packet drivers, which are distributed under the GPL. */ |
| 6 |
|
| 7 |
#ifndef _8390_h |
| 8 |
#define _8390_h |
| 9 |
|
| 10 |
#include <linux/config.h> |
| 11 |
#include <linux/if_ether.h> |
| 12 |
#include <linux/ioport.h> |
| 13 |
#include <linux/skbuff.h> |
| 14 |
|
| 15 |
#define TX_2X_PAGES 12 |
| 16 |
#define TX_1X_PAGES 6 |
| 17 |
|
| 18 |
#define TX_PAGES TX_2X_PAGES |
| 19 |
|
| 20 |
#define ETHER_ADDR_LEN 6 |
| 21 |
|
| 22 |
/* The 8390 specific per-packet-header format. */ |
| 23 |
struct e8390_pkt_hdr { |
| 24 |
unsigned char status; /* status */ |
| 25 |
unsigned char next; /* pointer to next packet. */ |
| 26 |
unsigned short count; /* header + packet length in bytes */ |
| 27 |
}; |
| 28 |
|
| 29 |
#ifdef notdef |
| 30 |
extern int ei_debug; |
| 31 |
#else |
| 32 |
#define ei_debug 1 |
| 33 |
#endif |
| 34 |
|
| 35 |
#ifndef HAVE_AUTOIRQ |
| 36 |
/* From auto_irq.c */ |
| 37 |
extern void autoirq_setup(int waittime); |
| 38 |
extern unsigned long autoirq_report(int waittime); |
| 39 |
#endif |
| 40 |
|
| 41 |
/* Most of these entries should be in 'struct net_device' (or most of the |
| 42 |
things in there should be here!) */ |
| 43 |
/* You have one of these per-board */ |
| 44 |
struct ei_device { |
| 45 |
const char *name; |
| 46 |
void (*reset_8390)(struct net_device *); |
| 47 |
void (*get_8390_hdr)(struct net_device *, struct e8390_pkt_hdr *, int); |
| 48 |
void (*block_output)(struct net_device *, int, const unsigned char *, int); |
| 49 |
void (*block_input)(struct net_device *, int, struct sk_buff *, int); |
| 50 |
unsigned char mcfilter[8]; |
| 51 |
unsigned open:1; |
| 52 |
unsigned word16:1; /* We have the 16-bit (vs 8-bit) version of the card. */ |
| 53 |
unsigned txing:1; /* Transmit Active */ |
| 54 |
unsigned irqlock:1; /* 8390's intrs disabled when '1'. */ |
| 55 |
unsigned dmaing:1; /* Remote DMA Active */ |
| 56 |
unsigned char tx_start_page, rx_start_page, stop_page; |
| 57 |
unsigned char current_page; /* Read pointer in buffer */ |
| 58 |
unsigned char interface_num; /* Net port (AUI, 10bT.) to use. */ |
| 59 |
unsigned char txqueue; /* Tx Packet buffer queue length. */ |
| 60 |
short tx1, tx2; /* Packet lengths for ping-pong tx. */ |
| 61 |
short lasttx; /* Alpha version consistency check. */ |
| 62 |
unsigned char saved_irq; /* Original dev->irq value. */ |
| 63 |
struct net_device_stats stat; /* The new statistics table. */ |
| 64 |
spinlock_t page_lock; /* Page register locks */ |
| 65 |
unsigned long priv; /* Private field to store bus IDs etc. */ |
| 66 |
}; |
| 67 |
|
| 68 |
/* The maximum number of 8390 interrupt service routines called per IRQ. */ |
| 69 |
#define MAX_SERVICE 12 |
| 70 |
|
| 71 |
/* The maximum time waited (in jiffies) before assuming a Tx failed. (20ms) */ |
| 72 |
#define TX_TIMEOUT (20*HZ/100) |
| 73 |
|
| 74 |
#define ei_status (*(struct ei_device *)(dev->priv)) |
| 75 |
|
| 76 |
/* Some generic ethernet register configurations. */ |
| 77 |
#define E8390_TX_IRQ_MASK 0xa /* For register EN0_ISR */ |
| 78 |
#define E8390_RX_IRQ_MASK 0x5 |
| 79 |
#define E8390_RXCONFIG 0x4 /* EN0_RXCR: broadcasts, no multicast,errors */ |
| 80 |
#define E8390_RXOFF 0x20 /* EN0_RXCR: Accept no packets */ |
| 81 |
#define E8390_TXCONFIG 0x00 /* EN0_TXCR: Normal transmit mode */ |
| 82 |
#define E8390_TXOFF 0x02 /* EN0_TXCR: Transmitter off */ |
| 83 |
|
| 84 |
/* Register accessed at EN_CMD, the 8390 base addr. */ |
| 85 |
#define E8390_STOP 0x01 /* Stop and reset the chip */ |
| 86 |
#define E8390_START 0x02 /* Start the chip, clear reset */ |
| 87 |
#define E8390_TRANS 0x04 /* Transmit a frame */ |
| 88 |
#define E8390_RREAD 0x08 /* Remote read */ |
| 89 |
#define E8390_RWRITE 0x10 /* Remote write */ |
| 90 |
#define E8390_NODMA 0x20 /* Remote DMA */ |
| 91 |
#define E8390_PAGE0 0x00 /* Select page chip registers */ |
| 92 |
#define E8390_PAGE1 0x40 /* using the two high-order bits */ |
| 93 |
#define E8390_PAGE2 0x80 /* Page 3 is invalid. */ |
| 94 |
|
| 95 |
#define E8390_CMD 0x00 /* The command register (for all pages) */ |
| 96 |
/* Page 0 register offsets. */ |
| 97 |
#define EN0_CLDALO 0x01 /* Low byte of current local dma addr RD */ |
| 98 |
#define EN0_STARTPG 0x01 /* Starting page of ring bfr WR */ |
| 99 |
#define EN0_CLDAHI 0x02 /* High byte of current local dma addr RD */ |
| 100 |
#define EN0_STOPPG 0x02 /* Ending page +1 of ring bfr WR */ |
| 101 |
#define EN0_BOUNDARY 0x03 /* Boundary page of ring bfr RD WR */ |
| 102 |
#define EN0_TSR 0x04 /* Transmit status reg RD */ |
| 103 |
#define EN0_TPSR 0x04 /* Transmit starting page WR */ |
| 104 |
#define EN0_NCR 0x05 /* Number of collision reg RD */ |
| 105 |
#define EN0_TCNTLO 0x05 /* Low byte of tx byte count WR */ |
| 106 |
#define EN0_FIFO 0x06 /* FIFO RD */ |
| 107 |
#define EN0_TCNTHI 0x06 /* High byte of tx byte count WR */ |
| 108 |
#define EN0_ISR 0x07 /* Interrupt status reg RD WR */ |
| 109 |
#define EN0_CRDALO 0x08 /* low byte of current remote dma address RD */ |
| 110 |
#define EN0_RSARLO 0x08 /* Remote start address reg 0 */ |
| 111 |
#define EN0_CRDAHI 0x09 /* high byte, current remote dma address RD */ |
| 112 |
#define EN0_RSARHI 0x09 /* Remote start address reg 1 */ |
| 113 |
#define EN0_RCNTLO 0x0a /* Remote byte count reg WR */ |
| 114 |
#define EN0_RCNTHI 0x0b /* Remote byte count reg WR */ |
| 115 |
#define EN0_RSR 0x0c /* rx status reg RD */ |
| 116 |
#define EN0_RXCR 0x0c /* RX configuration reg WR */ |
| 117 |
#define EN0_TXCR 0x0d /* TX configuration reg WR */ |
| 118 |
#define EN0_COUNTER0 0x0d /* Rcv alignment error counter RD */ |
| 119 |
#define EN0_DCFG 0x0e /* Data configuration reg WR */ |
| 120 |
#define EN0_COUNTER1 0x0e /* Rcv CRC error counter RD */ |
| 121 |
#define EN0_IMR 0x0f /* Interrupt mask reg WR */ |
| 122 |
#define EN0_COUNTER2 0x0f /* Rcv missed frame error counter RD */ |
| 123 |
|
| 124 |
/* Bits in EN0_ISR - Interrupt status register */ |
| 125 |
#define ENISR_RX 0x01 /* Receiver, no error */ |
| 126 |
#define ENISR_TX 0x02 /* Transmitter, no error */ |
| 127 |
#define ENISR_RX_ERR 0x04 /* Receiver, with error */ |
| 128 |
#define ENISR_TX_ERR 0x08 /* Transmitter, with error */ |
| 129 |
#define ENISR_OVER 0x10 /* Receiver overwrote the ring */ |
| 130 |
#define ENISR_COUNTERS 0x20 /* Counters need emptying */ |
| 131 |
#define ENISR_RDC 0x40 /* remote dma complete */ |
| 132 |
#define ENISR_RESET 0x80 /* Reset completed */ |
| 133 |
#define ENISR_ALL 0x3f /* Interrupts we will enable */ |
| 134 |
|
| 135 |
/* Bits in EN0_DCFG - Data config register */ |
| 136 |
#define ENDCFG_WTS 0x01 /* word transfer mode selection */ |
| 137 |
|
| 138 |
/* Page 1 register offsets. */ |
| 139 |
#define EN1_PHYS 0x01 /* This board's physical enet addr RD WR */ |
| 140 |
#define EN1_PHYS_SHIFT(i) (i+1) /* Get and set mac address */ |
| 141 |
#define EN1_CURPAG 0x07 /* Current memory page RD WR */ |
| 142 |
#define EN1_MULT 0x08 /* Multicast filter mask array (8 bytes) RD WR */ |
| 143 |
#define EN1_MULT_SHIFT(i) (8+i) /* Get and set multicast filter */ |
| 144 |
|
| 145 |
/* Bits in received packet status byte and EN0_RSR*/ |
| 146 |
#define ENRSR_RXOK 0x01 /* Received a good packet */ |
| 147 |
#define ENRSR_CRC 0x02 /* CRC error */ |
| 148 |
#define ENRSR_FAE 0x04 /* frame alignment error */ |
| 149 |
#define ENRSR_FO 0x08 /* FIFO overrun */ |
| 150 |
#define ENRSR_MPA 0x10 /* missed pkt */ |
| 151 |
#define ENRSR_PHY 0x20 /* physical/multicast address */ |
| 152 |
#define ENRSR_DIS 0x40 /* receiver disable. set in monitor mode */ |
| 153 |
#define ENRSR_DEF 0x80 /* deferring */ |
| 154 |
|
| 155 |
/* Transmitted packet status, EN0_TSR. */ |
| 156 |
#define ENTSR_PTX 0x01 /* Packet transmitted without error */ |
| 157 |
#define ENTSR_ND 0x02 /* The transmit wasn't deferred. */ |
| 158 |
#define ENTSR_COL 0x04 /* The transmit collided at least once. */ |
| 159 |
#define ENTSR_ABT 0x08 /* The transmit collided 16 times, and was deferred. */ |
| 160 |
#define ENTSR_CRS 0x10 /* The carrier sense was lost. */ |
| 161 |
#define ENTSR_FU 0x20 /* A "FIFO underrun" occurred during transmit. */ |
| 162 |
#define ENTSR_CDH 0x40 /* The collision detect "heartbeat" signal was lost. */ |
| 163 |
#define ENTSR_OWC 0x80 /* There was an out-of-window collision. */ |
| 164 |
|
| 165 |
#endif /* _8390_h */ |