| 1 |
What: /config/pcie-gadget |
| 2 |
Date: Feb 2011 |
| 3 |
KernelVersion: 2.6.37 |
| 4 |
Contact: Pratyush Anand <[email protected]> |
| 5 |
Description: |
| 6 |
|
| 7 |
Interface is used to configure selected dual mode PCIe controller |
| 8 |
as device and then program its various registers to configure it |
| 9 |
as a particular device type. |
| 10 |
This interfaces can be used to show spear's PCIe device capability. |
| 11 |
|
| 12 |
Nodes are only visible when configfs is mounted. To mount configfs |
| 13 |
in /config directory use:: |
| 14 |
|
| 15 |
# mount -t configfs none /config/ |
| 16 |
|
| 17 |
For nth PCIe Device Controller /config/pcie-gadget.n/: |
| 18 |
|
| 19 |
=============== ====================================================== |
| 20 |
link used to enable ltssm and read its status. |
| 21 |
int_type used to configure and read type of supported interrupt |
| 22 |
no_of_msi used to configure number of MSI vector needed and |
| 23 |
to read no of MSI granted. |
| 24 |
inta write 1 to assert INTA and 0 to de-assert. |
| 25 |
send_msi write MSI vector to be sent. |
| 26 |
vendor_id used to write and read vendor id (hex) |
| 27 |
device_id used to write and read device id (hex) |
| 28 |
bar0_size used to write and read bar0_size |
| 29 |
bar0_address used to write and read bar0 mapped area in hex. |
| 30 |
bar0_rw_offset used to write and read offset of bar0 where bar0_data |
| 31 |
will be written or read. |
| 32 |
bar0_data used to write and read data at bar0_rw_offset. |
| 33 |
=============== ====================================================== |