| 1 |
The steps below let you create and install the firmware file. For |
| 2 |
a .uf2 type file taken from the MicroPython downloads source only |
| 3 |
step 4 is needed. For the .hex version of the firmware file, steps |
| 4 |
1, 3 and 4 are required. |
| 5 |
|
| 6 |
1. Download and install u2fconv.py. It is available e.g. in the tools |
| 7 |
directory of MicroPython. |
| 8 |
|
| 9 |
2. Create a firmware for the SEEED nrf52840 if needed, with the command |
| 10 |
|
| 11 |
`make BOARD=SEEED_XIAO_NRF52 -j5` |
| 12 |
|
| 13 |
in the directory build-SEEED_XIAO_NRF52-s140. The firmware file will have the |
| 14 |
name firmware.uf2. |
| 15 |
|
| 16 |
3. Create the .uf2 file if needed in the build directory with the command: |
| 17 |
|
| 18 |
`uf2conv.py -c -f 0xADA52840 -o firmware.uf2 firmware.hex` |
| 19 |
|
| 20 |
It must report the start address as 0x27000. If you omit the -o option, |
| 21 |
the output file will have the name flash.uf2. |
| 22 |
|
| 23 |
4. Enable the upload mode by pushing reset twice or calling |
| 24 |
machine.bootloader() and copy the file firmware.uf2 to the board drive, |
| 25 |
which will pop up on your PC. |
| 26 |
|
| 27 |
In case the XIAO bootloader is lost or overwritten, it can be found |
| 28 |
at https://github.com/Seeed-Studio/Adafruit_nRF52_Arduino.git in different |
| 29 |
formats. Using a JLINK adapter or interface, it can be uploaded as hex version. |
| 30 |
The bootloader is as well available through the Arduino IDE. |
| 31 |
|