| 1 |
# SPDX-License-Identifier: GPL-2.0 |
| 2 |
config WILC1000 |
| 3 |
tristate |
| 4 |
help |
| 5 |
Add support for the Atmel WILC1000 802.11 b/g/n SoC. |
| 6 |
This provides Wi-FI over an SDIO or SPI interface, and |
| 7 |
is usually found in IoT devices. |
| 8 |
|
| 9 |
This module only support IEEE 802.11n WiFi. |
| 10 |
|
| 11 |
config WILC1000_SDIO |
| 12 |
tristate "Atmel WILC1000 SDIO (WiFi only)" |
| 13 |
depends on CFG80211 && INET && MMC |
| 14 |
select WILC1000 |
| 15 |
help |
| 16 |
This module adds support for the SDIO interface of adapters using |
| 17 |
WILC1000 chipset. The Atmel WILC1000 SDIO is a full speed interface. |
| 18 |
It meets SDIO card specification version 2.0. The interface supports |
| 19 |
the 1-bit/4-bit SD transfer mode at the clock range of 0-50 MHz. |
| 20 |
The host can use this interface to read and write from any register |
| 21 |
within the chip as well as configure the WILC1000 for data DMA. |
| 22 |
To use this interface, pin9 (SDIO_SPI_CFG) must be grounded. Select |
| 23 |
this if your platform is using the SDIO bus. |
| 24 |
|
| 25 |
config WILC1000_SPI |
| 26 |
tristate "Atmel WILC1000 SPI (WiFi only)" |
| 27 |
depends on CFG80211 && INET && SPI |
| 28 |
select WILC1000 |
| 29 |
select CRC7 |
| 30 |
select CRC_ITU_T |
| 31 |
help |
| 32 |
This module adds support for the SPI interface of adapters using |
| 33 |
WILC1000 chipset. The Atmel WILC1000 has a Serial Peripheral |
| 34 |
Interface (SPI) that operates as a SPI slave. This SPI interface can |
| 35 |
be used for control and for serial I/O of 802.11 data. The SPI is a |
| 36 |
full-duplex slave synchronous serial interface that is available |
| 37 |
immediately following reset when pin 9 (SDIO_SPI_CFG) is tied to |
| 38 |
VDDIO. Select this if your platform is using the SPI bus. |
| 39 |
|
| 40 |
config WILC1000_HW_OOB_INTR |
| 41 |
bool "WILC1000 out of band interrupt" |
| 42 |
depends on WILC1000_SDIO |
| 43 |
help |
| 44 |
This option enables out-of-band interrupt support for the WILC1000 |
| 45 |
chipset. This OOB interrupt is intended to provide a faster interrupt |
| 46 |
mechanism for SDIO host controllers that don't support SDIO interrupt. |
| 47 |
Select this option If the SDIO host controller in your platform |
| 48 |
doesn't support SDIO time division interrupt. |