| 1 |
============================== |
| 2 |
LAN9303 Ethernet switch driver |
| 3 |
============================== |
| 4 |
|
| 5 |
The LAN9303 is a three port 10/100 Mbps ethernet switch with integrated phys for |
| 6 |
the two external ethernet ports. The third port is an RMII/MII interface to a |
| 7 |
host conduit network interface (e.g. fixed link). |
| 8 |
|
| 9 |
|
| 10 |
Driver details |
| 11 |
============== |
| 12 |
|
| 13 |
The driver is implemented as a DSA driver, see ``Documentation/networking/dsa/dsa.rst``. |
| 14 |
|
| 15 |
See ``Documentation/devicetree/bindings/net/dsa/lan9303.txt`` for device tree |
| 16 |
binding. |
| 17 |
|
| 18 |
The LAN9303 can be managed both via MDIO and I2C, both supported by this driver. |
| 19 |
|
| 20 |
At startup the driver configures the device to provide two separate network |
| 21 |
interfaces (which is the default state of a DSA device). Due to HW limitations, |
| 22 |
no HW MAC learning takes place in this mode. |
| 23 |
|
| 24 |
When both user ports are joined to the same bridge, the normal HW MAC learning |
| 25 |
is enabled. This means that unicast traffic is forwarded in HW. Broadcast and |
| 26 |
multicast is flooded in HW. STP is also supported in this mode. The driver |
| 27 |
support fdb/mdb operations as well, meaning IGMP snooping is supported. |
| 28 |
|
| 29 |
If one of the user ports leave the bridge, the ports goes back to the initial |
| 30 |
separated operation. |
| 31 |
|
| 32 |
|
| 33 |
Driver limitations |
| 34 |
================== |
| 35 |
|
| 36 |
- Support for VLAN filtering is not implemented |
| 37 |
- The HW does not support VLAN-specific fdb entries |