| 1 |
Antal Novak <[email protected]> sent these instructions for imwheel on FreeBSD, |
| 2 |
plus a few patches...ENJOY! (slightly edited for content and to fit your screen) |
| 3 |
|
| 4 |
I currenly have FreeBSD-3.0 (although this should work with 2.2.6, or even |
| 5 |
earlier) and a Microsoft IntelliMouse PS/2. |
| 6 |
I did the following to get it to work: |
| 7 |
|
| 8 |
1) To run moused, use the -t sysmouse (NOT PS/2!!!) argument for a ps/2 |
| 9 |
mouse, or -t intellimouse for the serial version (note, i've never tried |
| 10 |
the serial version, so i'm not *positive* it will work... I'd like some |
| 11 |
feedback on this if possible) |
| 12 |
|
| 13 |
2) Run imwheel using method #1 as described in the imwheel README. |
| 14 |
However, your XF86Config *must* be set up as follows (since there is no |
| 15 |
FreeBSD XFree86 support for IMPS/2 because it can't preinitialize the ps/2 |
| 16 |
port): |
| 17 |
|
| 18 |
Section "Pointer" |
| 19 |
Protocol "IntelliMouse" |
| 20 |
Device "/dev/sysmouse" |
| 21 |
ZAxisMapping 4 5 |
| 22 |
EndSection |
| 23 |
|
| 24 |
You can add other options if you want; however, it is important that you use |
| 25 |
the IntelliMouse protocol and read from /dev/sysmouse (this is the passthrough |
| 26 |
device for moused). Basically, the way moused works is that you can use *ANY* |
| 27 |
protocol for reading /dev/sysmouse. Therefore, since we can't use IMPS/2, we |
| 28 |
simply use IntelliMouse, so X thinks it's a serial IntelliMouse, and everything |
| 29 |
is passed through! |
| 30 |
|
| 31 |
Oh yeah, one final note, gpm is NOT needed (nor will it even compile) on |
| 32 |
FreeBSD. |