| 1 |
# This file was adapted from Mandrake Linux 8.1 |
| 2 |
# |
| 3 |
# These options are used to tune the hard drives - |
| 4 |
# read the hdparm man page for more information |
| 5 |
|
| 6 |
# Set this to 1 to enable DMA. This might cause some |
| 7 |
# data corruption on certain chipset / hard drive |
| 8 |
# combinations. This is used with the "-d" option |
| 9 |
|
| 10 |
# USE_DMA=1 |
| 11 |
|
| 12 |
# Multiple sector I/O. a feature of most modern IDE hard drives, |
| 13 |
# permitting the transfer of multiple sectors per I/O interrupt, |
| 14 |
# rather than the usual one sector per interrupt. When this feature |
| 15 |
# is enabled, it typically reduces operating system overhead for disk |
| 16 |
# I/O by 30-50%. On many systems, it also provides increased non-DMA |
| 17 |
# data throughput of anywhere from 5% to 50%. Some drives, however |
| 18 |
# (most notably the older WD Caviar series), seem to run slower with |
| 19 |
# multiple mode enabled. Under rare circumstances, such failures can |
| 20 |
# result in # massive filesystem corruption. USE WITH CAUTION AND BACKUP. |
| 21 |
# This is the sector count for multiple sector I/O - the "-m" option |
| 22 |
# |
| 23 |
# MULTIPLE_IO=8 |
| 24 |
|
| 25 |
# (E)IDE 32-bit I/O support (to interface card) |
| 26 |
# |
| 27 |
# EIDE_32BIT=1 |
| 28 |
|
| 29 |
# Enable drive read-lookahead |
| 30 |
# |
| 31 |
# LOOKAHEAD=1 |
| 32 |
|
| 33 |
# Add extra parameters here if wanted |
| 34 |
# Other flags you might want to experiment with are -u1, -A1 and -W1 |
| 35 |
# See the hdparm manpage (man hdparm) for details and more options. |
| 36 |
# |
| 37 |
EXTRA_PARAMS= |