# This file was adapted from Mandrake Linux 8.1 # # These options are used to tune the hard drives - # read the hdparm man page for more information # Set this to 1 to enable DMA. This might cause some # data corruption on certain chipset / hard drive # combinations. This is used with the "-d" option # USE_DMA=1 # Multiple sector I/O. a feature of most modern IDE hard drives, # permitting the transfer of multiple sectors per I/O interrupt, # rather than the usual one sector per interrupt. When this feature # is enabled, it typically reduces operating system overhead for disk # I/O by 30-50%. On many systems, it also provides increased non-DMA # data throughput of anywhere from 5% to 50%. Some drives, however # (most notably the older WD Caviar series), seem to run slower with # multiple mode enabled. Under rare circumstances, such failures can # result in # massive filesystem corruption. USE WITH CAUTION AND BACKUP. # This is the sector count for multiple sector I/O - the "-m" option # # MULTIPLE_IO=8 # (E)IDE 32-bit I/O support (to interface card) # # EIDE_32BIT=1 # Enable drive read-lookahead # # LOOKAHEAD=1 # Add extra parameters here if wanted # Other flags you might want to experiment with are -u1, -A1 and -W1 # See the hdparm manpage (man hdparm) for details and more options. # EXTRA_PARAMS=