Debian Codegraph @

/

0 files · 0 symbols
README (full)
			NETSCRIPT version 5.3

The firewall and network configuration system for advanced Linux 
firewalls/routers, and it is NOT meant to be used on servers!

Copyright 1995-2014 Matthew Grant <[email protected]>
	  1998,1999 Dave Cinege <[email protected]>

This script system for network setup has its roots in the original firewalling 
setup that Matthew Grant did for a firewall using kernel 1.2.x.  Since then
it has been evolved through firewalls/routers on Linux kernels 2.0.x, 2.2.x 
2.4.x, 2.6.x, and 3.x.

Version 1 was the stuff under kernel 2.0.x, version 2 on LRP 2.9.4 Kilimanjaro, 
Materhorn, and Eiger under 2.2, version 3.0 for Debian under kernel 2.2.x, and
this one is for Debian under kernel 2.4.x and 2.6.x.

You should install bridge-utils for bridging, iproute2 tools and iptables to
use these scripts.  Your kernel will need to be compiled for Advanced Router
support and have almost the configuration options turned on.  It is also 
recomended that routing software like zebra be installed on the system as it 
will make things like static routing and complex routing a lot easier to 
handle.

A kernel configuration of what is needed can be found in 2.4.x-kernel.config
It is also a good idea to add kernel patches from the iptables source tar ball,
especially the IPv6 ones for logging support. The scripts will load all the 
neccessary modules for QoS and iptables.  

Documentation for this system is sparse at the moment, but more will be done
when the time is found to do it.

When installed, most of the configuration you will need will be found in 
/etc/netscript/network.conf including lower level protocol 
daemons/configuration programs like ciped, pppd, or wanconfig. 

You will have to configure the firewall using the iptables commands directly. 
Don't forget to save the configurations using the 
'netscript ipfilter|ip6filter save' commands! Unlike the last version, 
the firewalling and filtering is no longer configured from network.conf.  
This has been done as stateful filtering obviates the need for great 
complexity in the firewall scripts, and  more flexibility is possible.  
You have to get down and get dirty with iptables and learn it, which is a 
good thing to do if you are running this to build a network - you should 
understand things fully, or else you will get things wrong.

dir .bzr-builddeb/
dir debian/
file 2.4.x-kernel.config
file BUGS
file COPYING
file ChangeLog
file LICENSE
file Makefile
file README
file README.etc
file TODO
file if.conf
file if.conf.5
file ipfilter.conf
file ipfilter.conf.5
file netscript
file netscript-2.4.conf.5
file netscript-hotplug
file netscript-ipfilter
file netscript-ipfilter.8
file netscript-ipfilter.conf.5
file netscript.8
file netscript.ppp.ip-down
file netscript.ppp.ip-up
file network-ipfilter.conf
file network-ipfilter.conf.5
file network.conf
file network.conf.5
file network.conf.d.00default-eth0-dhcp.conf
file qos.conf
file qos.conf.5
file wep.conf