| 1 |
### Via dfu-util |
| 2 |
|
| 3 |
This board can be programmed via DFU bootloader, using e.g. [dfu-util](http://dfu-util.sourceforge.net/). |
| 4 |
To enter the DFU bootloader, double tap the recessed reset button, or you can use `machine.bootloader()` from the MicroPython REPL. |
| 5 |
|
| 6 |
The Arduino Opta indicates its DFU state by blinking the green LED above the RESET button. |
| 7 |
|
| 8 |
**NOTE**: The board might remain in DFU mode after the upload, a simple reset will bring the board back to Run-Time. |
| 9 |
|
| 10 |
```bash |
| 11 |
dfu-util -w -a 0 -d 2341:0364 -D build-ARDUINO_OPTA/firmware.dfu |
| 12 |
``` |
| 13 |
|
| 14 |
Or from MicroPython source repository, making sure the current directory is `ports/stm32`: |
| 15 |
|
| 16 |
```bash |
| 17 |
make BOARD=ARDUINO_OPTA deploy |
| 18 |
``` |