| 1 |
The SAMD21 Xplained Pro board is shipped without a bootloader. For use |
| 2 |
with MicroPyhton a suitable bootloader has be be installed first. The |
| 3 |
following procedure has been found to work and be simple: |
| 4 |
|
| 5 |
1. Get the bootloader from https://micropython.org/resources/firmware/bootloader-xplained-pro-v3.16.0-15-gaa52b22.hex. |
| 6 |
2. Connect your board to the debug port. A drive with the name XPLAINED |
| 7 |
shall appear. |
| 8 |
3. Copy the Intel hex file of the bootloader to that drive. |
| 9 |
4. Connect your board to the target port. A drive with the name SAMD21XPL should |
| 10 |
appear. If not, push reset twice. Then it should appear. If that does not |
| 11 |
happen, the bootloader was not properly installed or is not compatible. |
| 12 |
5. Copy the MicroPython firmware, a .uf2 file, to the SAMD21 drive. When the SAMD21 |
| 13 |
drive disappears, MicroPython is installed. |
| 14 |
|
| 15 |
From now on only steps 4 and 5 are needed to update MicroPython. You can use the |
| 16 |
usual methods to invoke the bootloader, namely: |
| 17 |
|
| 18 |
- Push Reset twice. |
| 19 |
- Call machine.bootloader(). |
| 20 |
- Use the touch 1200 procedure by switching the USB baud rate to 1200 baud and back. |
| 21 |
|
| 22 |
At the above link above there are as well .uf2 versions of the bootloader |
| 23 |
which one can install using steps 5. and 6. above once a .uf2 capable |
| 24 |
bootloader is installed. |