| 1 |
## 1. Deploy the MicroPython firmware to the Metro M7 board. |
| 2 |
|
| 3 |
The Metro M7 board comes pre-installed with a UF2 bootloader. It can |
| 4 |
be started by pushing reset twice. Then the bootloader drive will |
| 5 |
appear. If that does not happen or the bootloader was lost, you can |
| 6 |
reinstall the bootloader using the instructions by Adafruit |
| 7 |
here: https://learn.adafruit.com/adafruit-metro-m7-microsd/installing-the-bootloader |
| 8 |
|
| 9 |
Once the bootloader is installed and started, you can install MicroPython |
| 10 |
by copying the .uf2 version of the firmware file to the bootloader |
| 11 |
drive. A LED on the board will start flickering, indicating that the |
| 12 |
upload is ongoing. Once the upload is complete, the drive icon will |
| 13 |
disappear. Wait until the LED stops flickering. In rare cases there |
| 14 |
may be an error message coming up, especially when there are only few |
| 15 |
or no changes in the firmware file. Then just repeat the upload. |