Debian Codegraph @

upstream/opensuse-tumbleweed/man8/plipconfig.8

raw
1 .TH PLIPCONFIG 8 "2025-09-10" "net\-tools" "Linux System Administrator's Manual"
2
3 .SH NAME
4 plipconfig \- fine tune PLIP device parameters
5
6 .SH SYNOPSIS
7 .B plipconfig
8 .I Interface
9 .RB [ nibble
10 .IR NI ]
11 .RB [ trigger
12 .IR NT ]
13 .P
14 .B plipconfig
15 .RB [ \-V ]
16 .RB [ \-\-version ]
17 .RB [ \-h ]
18 .RB [ \-\-help ]
19
20 .SH DESCRIPTION
21 .B Plipconfig
22 is used to (hopefully) improve PLIP performance by changing the default
23 timing parameters used by the PLIP protocol. Results are dependent on
24 the parallel port hardware, cable, and the CPU speed of each machine
25 on each end of the PLIP link.
26 .LP
27 If the single
28 .I interface
29 argument is given,
30 .B plipconfig
31 displays the status of the given interface
32 only. Otherwise, it will try to set the options.
33
34 .SH OPTIONS
35 .TP
36 \fBnibble\fP \fI NI\fP
37 Sets the nibble wait value in microseconds. Default is 3000.
38 .TP
39 \fBtrigger\fP \fINT\fP
40 Sets the trigger wait value in microseconds. Default is 500.
41
42 .P
43 PLIP speed can in some cases be improved by lowering the default values.
44 Values which are too low may cause excess use of CPU, poor interrupt
45 response time resulting in serial ports dropping characters, or in dropping
46 of PLIP packets. Changing the plip MTU can also affect PLIP speed.
47
48 .SH NOTE
49 If you get no response it is far more likely the irq is wrong and needs
50 setting with ifconfig. The few cases where the default parameters will
51 be too fast are those using very long cables. Something you should
52 never do as the parallel port is not specified or designed for driving
53 long cable runs.
54
55 .SH SEE ALSO
56 Homepage of the \fInet\-tools\fP project:
57 .UR https://net-tools.sourceforge.io
58 .UE
59
60 .P
61 .BR ifconfig (8)
62
63 .SH AUTHOR
64 .TP
65 John Paul Morrison
66 <[email protected]>, <[email protected]>