Debian Codegraph @

tests/manual

raw
1 Test-case lomiri-app-launch/legacy-app
2 <dl>
3 <dt>Ensure that the system-settings is installed: <tt>apt-cache policy lomiri-system-settings</tt></dt>
4 <dd>One of the versions in the version table should a <tt>***</tt> next to it</dd>
5 <dt>Ensure the settings app is not currently running: <tt>lomiri-app-list</tt></dt>
6 <dd>Settings shouldn't be listed</dd>
7 <dt>Launch the settings application: <tt>lomiri-app-launch lomiri-system-settings</tt></dt>
8 <dd>The settings application should be brought to focus and shown to the user</dd>
9 </dl>
10
11 Test-case lomiri-app-launch/secondary-activation
12 <dl>
13 <dt>Run test case: lomiri-app-launch/legacy-app</dt>
14 <dd>Everything behaves as expected</dd>
15 <dt>Use the launcher to return to the home screen</dt>
16 <dd>The settings app is no longer shown</dd>
17 <dt>Send a URL to the service: <tt>lomiri-app-launch lomiri-system-settings settings:///system/battery</tt></dt>
18 <dd>The settings application should come back into focus and be on the power settings pane</dd>
19 </dl>
20
21 Test-case lomiri-app-launch/helper-run
22 <dl>
23 <dt>NOTE: Test is theoretical today, needs other components to be written</dt>
24 <dt>Get a device that supports sending SMS</dt>
25 <dd>Typically this is a phone</dd>
26 <dt>Note the SMS sent count visible on the lock screen infographic for this user</dt>
27 <dt>Start the messaging app</dt>
28 <dt>Send an SMS</dt>
29 <dd>SMS should report as being sent successfully</dd>
30 <dt>Wait approximately 1 minute</dt>
31 <dd>Screen should lock</dd>
32 <dt>Look at the lock screen infographic for the SMS sent count</dt>
33 <dd>Count should have incremented by 1</dd>
34 </dl>
35
36 Test-case lomiri-app-launch/cgroup-containment
37 <dl>
38 <dt>Install the Terminal app if not already installed</dt>
39 <dd>It can be found in the Application Store if not currently installed</dd>
40 <dt>Launch the Terminal app</dt>
41 <dd>A new application should open with a terminal prompt where you can type commands</dd>
42 <dt>Ensure the Terminal is in a terminal specific cgroup</dt>
43 <dd>Type the command <tt>cat /proc/self/cgroup</tt> on the Terminal app.</dd>
44 <dd>Under the "freeze" cgroup the end of the path should include the AppID of the terminal. An example would be (the version many change): <tt>4:freezer:/user.slice/user-32011.slice/session-c2.scope/upstart/application-click-com.lomiri.terminal_terminal_0.5.106</tt></dd>
45 </dl>