| 1 |
// SPDX-License-Identifier: GPL-2.0-or-later |
| 2 |
/* |
| 3 |
* Digsy MTC board Device Tree Source |
| 4 |
* |
| 5 |
* Copyright (C) 2009 Semihalf |
| 6 |
* |
| 7 |
* Based on the CM5200 by M. Balakowicz |
| 8 |
*/ |
| 9 |
|
| 10 |
/include/ "mpc5200b.dtsi" |
| 11 |
|
| 12 |
&gpt0 { gpio-controller; fsl,has-wdt; }; |
| 13 |
&gpt1 { gpio-controller; }; |
| 14 |
|
| 15 |
/ { |
| 16 |
model = "intercontrol,digsy-mtc"; |
| 17 |
compatible = "intercontrol,digsy-mtc"; |
| 18 |
|
| 19 |
memory@0 { |
| 20 |
reg = <0x00000000 0x02000000>; // 32MB |
| 21 |
}; |
| 22 |
|
| 23 |
soc5200@f0000000 { |
| 24 |
rtc@800 { |
| 25 |
status = "disabled"; |
| 26 |
}; |
| 27 |
|
| 28 |
psc@2000 { // PSC1 |
| 29 |
status = "disabled"; |
| 30 |
}; |
| 31 |
|
| 32 |
psc@2200 { // PSC2 |
| 33 |
status = "disabled"; |
| 34 |
}; |
| 35 |
|
| 36 |
psc@2400 { // PSC3 |
| 37 |
status = "disabled"; |
| 38 |
}; |
| 39 |
|
| 40 |
psc@2600 { // PSC4 |
| 41 |
compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; |
| 42 |
}; |
| 43 |
|
| 44 |
psc@2800 { // PSC5 |
| 45 |
compatible = "fsl,mpc5200b-psc-uart","fsl,mpc5200-psc-uart"; |
| 46 |
}; |
| 47 |
|
| 48 |
psc@2c00 { // PSC6 |
| 49 |
status = "disabled"; |
| 50 |
}; |
| 51 |
|
| 52 |
ethernet@3000 { |
| 53 |
phy-handle = <&phy0>; |
| 54 |
}; |
| 55 |
|
| 56 |
mdio@3000 { |
| 57 |
phy0: ethernet-phy@0 { |
| 58 |
reg = <0>; |
| 59 |
}; |
| 60 |
}; |
| 61 |
|
| 62 |
i2c@3d00 { |
| 63 |
eeprom@50 { |
| 64 |
compatible = "atmel,24c08"; |
| 65 |
reg = <0x50>; |
| 66 |
}; |
| 67 |
|
| 68 |
rtc@56 { |
| 69 |
compatible = "microcrystal,rv3029"; |
| 70 |
reg = <0x56>; |
| 71 |
}; |
| 72 |
|
| 73 |
rtc@68 { |
| 74 |
compatible = "dallas,ds1339"; |
| 75 |
reg = <0x68>; |
| 76 |
}; |
| 77 |
}; |
| 78 |
|
| 79 |
i2c@3d40 { |
| 80 |
status = "disabled"; |
| 81 |
}; |
| 82 |
}; |
| 83 |
|
| 84 |
pci@f0000d00 { |
| 85 |
interrupt-map-mask = <0xf800 0 0 7>; |
| 86 |
interrupt-map = <0xc000 0 0 1 &mpc5200_pic 0 0 3 |
| 87 |
0xc000 0 0 2 &mpc5200_pic 0 0 3 |
| 88 |
0xc000 0 0 3 &mpc5200_pic 0 0 3 |
| 89 |
0xc000 0 0 4 &mpc5200_pic 0 0 3>; |
| 90 |
clock-frequency = <0>; // From boot loader |
| 91 |
interrupts = <2 8 0 2 9 0 2 10 0>; |
| 92 |
bus-range = <0 0>; |
| 93 |
ranges = <0x42000000 0 0x80000000 0x80000000 0 0x10000000>, |
| 94 |
<0x02000000 0 0x90000000 0x90000000 0 0x10000000>, |
| 95 |
<0x01000000 0 0x00000000 0xa0000000 0 0x01000000>; |
| 96 |
}; |
| 97 |
|
| 98 |
localbus { |
| 99 |
ranges = <0 0 0xff000000 0x1000000 |
| 100 |
4 0 0x60000000 0x0001000>; |
| 101 |
|
| 102 |
// 16-bit flash device at LocalPlus Bus CS0 |
| 103 |
flash@0,0 { |
| 104 |
compatible = "cfi-flash"; |
| 105 |
reg = <0 0 0x1000000>; |
| 106 |
bank-width = <2>; |
| 107 |
device-width = <2>; |
| 108 |
#size-cells = <1>; |
| 109 |
#address-cells = <1>; |
| 110 |
|
| 111 |
partition@0 { |
| 112 |
label = "kernel"; |
| 113 |
reg = <0x0 0x00200000>; |
| 114 |
}; |
| 115 |
partition@200000 { |
| 116 |
label = "root"; |
| 117 |
reg = <0x00200000 0x00300000>; |
| 118 |
}; |
| 119 |
partition@500000 { |
| 120 |
label = "user"; |
| 121 |
reg = <0x00500000 0x00a00000>; |
| 122 |
}; |
| 123 |
partition@f00000 { |
| 124 |
label = "u-boot"; |
| 125 |
reg = <0x00f00000 0x100000>; |
| 126 |
}; |
| 127 |
}; |
| 128 |
|
| 129 |
can@4,0 { |
| 130 |
compatible = "nxp,sja1000"; |
| 131 |
reg = <4 0x000 0x80>; |
| 132 |
nxp,external-clock-frequency = <24000000>; |
| 133 |
interrupts = <1 2 3>; // Level-low |
| 134 |
}; |
| 135 |
|
| 136 |
can@4,100 { |
| 137 |
compatible = "nxp,sja1000"; |
| 138 |
reg = <4 0x100 0x80>; |
| 139 |
nxp,external-clock-frequency = <24000000>; |
| 140 |
interrupts = <1 2 3>; // Level-low |
| 141 |
}; |
| 142 |
|
| 143 |
serial@4,200 { |
| 144 |
compatible = "nxp,sc28l92"; |
| 145 |
reg = <4 0x200 0x10>; |
| 146 |
interrupts = <1 3 3>; |
| 147 |
}; |
| 148 |
}; |
| 149 |
}; |