Debian Codegraph @

scripts/dtc/include-prefixes/arm64/qcom/lemans-pmics.dtsi

raw
1 // SPDX-License-Identifier: BSD-3-Clause
2 /*
3 * Copyright (c) 2023, Linaro Limited
4 */
5
6 #include <dt-bindings/input/input.h>
7 #include <dt-bindings/spmi/spmi.h>
8
9 / {
10 thermal-zones {
11 pmm8654au_0_thermal: pm8775-0-thermal {
12 polling-delay-passive = <100>;
13
14 thermal-sensors = <&pmm8654au_0_temp_alarm>;
15
16 trips {
17 trip0 {
18 temperature = <105000>;
19 hysteresis = <0>;
20 type = "passive";
21 };
22
23 trip1 {
24 temperature = <125000>;
25 hysteresis = <0>;
26 type = "critical";
27 };
28 };
29 };
30
31 pmm8654au_1_thermal: pm8775-1-thermal {
32 polling-delay-passive = <100>;
33
34 thermal-sensors = <&pmm8654au_1_temp_alarm>;
35
36 trips {
37 trip0 {
38 temperature = <105000>;
39 hysteresis = <0>;
40 type = "passive";
41 };
42
43 trip1 {
44 temperature = <125000>;
45 hysteresis = <0>;
46 type = "critical";
47 };
48 };
49 };
50
51 pmm8654au_2_thermal: pm8775-2-thermal {
52 polling-delay-passive = <100>;
53
54 thermal-sensors = <&pmm8654au_2_temp_alarm>;
55
56 trips {
57 trip0 {
58 temperature = <105000>;
59 hysteresis = <0>;
60 type = "passive";
61 };
62
63 trip1 {
64 temperature = <125000>;
65 hysteresis = <0>;
66 type = "critical";
67 };
68 };
69 };
70
71 pmm8654au_3_thermal: pm8775-3-thermal {
72 polling-delay-passive = <100>;
73
74 thermal-sensors = <&pmm8654au_3_temp_alarm>;
75
76 trips {
77 trip0 {
78 temperature = <105000>;
79 hysteresis = <0>;
80 type = "passive";
81 };
82
83 trip1 {
84 temperature = <125000>;
85 hysteresis = <0>;
86 type = "critical";
87 };
88 };
89 };
90 };
91
92 reboot-mode {
93 compatible = "nvmem-reboot-mode";
94 nvmem-cells = <&reboot_reason>;
95 nvmem-cell-names = "reboot-mode";
96 mode-recovery = <0x01>;
97 mode-bootloader = <0x02>;
98 };
99 };
100
101 &spmi_bus {
102 pmm8654au_0: pmic@0 {
103 compatible = "qcom,pmm8654au", "qcom,spmi-pmic";
104 reg = <0x0 SPMI_USID>;
105 #address-cells = <1>;
106 #size-cells = <0>;
107
108 pmm8654au_0_temp_alarm: temp-alarm@a00 {
109 compatible = "qcom,spmi-temp-alarm";
110 reg = <0xa00>;
111 interrupts-extended = <&spmi_bus 0x0 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
112 #thermal-sensor-cells = <0>;
113 };
114
115 pmm8654au_0_pon: pon@1200 {
116 compatible = "qcom,pmk8350-pon";
117 reg = <0x1200>, <0x800>;
118 reg-names = "hlos", "pbs";
119
120 pmm8654au_0_pon_pwrkey: pwrkey {
121 compatible = "qcom,pmk8350-pwrkey";
122 interrupts-extended = <&spmi_bus 0x0 0x12 0x7 IRQ_TYPE_EDGE_BOTH>;
123 linux,code = <KEY_POWER>;
124 debounce = <15625>;
125 };
126
127 pmm8654au_0_pon_resin: resin {
128 compatible = "qcom,pmk8350-resin";
129 interrupts-extended = <&spmi_bus 0x0 0x12 0x6 IRQ_TYPE_EDGE_BOTH>;
130 debounce = <15625>;
131 status = "disabled";
132 };
133 };
134
135 pmm8654au_0_rtc: rtc@6100 {
136 compatible = "qcom,pmk8350-rtc";
137 reg = <0x6100>,
138 <0x6200>;
139 reg-names = "rtc",
140 "alarm";
141 interrupts = <0x0 0x62 0x1 IRQ_TYPE_EDGE_RISING>;
142 };
143
144 pmm8654au_0_gpios: gpio@8800 {
145 compatible = "qcom,pmm8654au-gpio", "qcom,spmi-gpio";
146 reg = <0x8800>;
147 gpio-controller;
148 gpio-ranges = <&pmm8654au_0_gpios 0 0 12>;
149 #gpio-cells = <2>;
150 interrupt-controller;
151 #interrupt-cells = <2>;
152 };
153
154 pmm8654au_0_sdam_0: nvram@7100 {
155 compatible = "qcom,spmi-sdam";
156 reg = <0x7100>;
157 #address-cells = <1>;
158 #size-cells = <1>;
159 ranges = <0 0x7100 0x100>;
160
161 reboot_reason: reboot-reason@48 {
162 reg = <0x48 0x1>;
163 bits = <1 7>;
164 };
165 };
166 };
167
168 pmm8654au_1: pmic@2 {
169 compatible = "qcom,pmm8654au", "qcom,spmi-pmic";
170 reg = <0x2 SPMI_USID>;
171 #address-cells = <1>;
172 #size-cells = <0>;
173
174 pmm8654au_1_temp_alarm: temp-alarm@a00 {
175 compatible = "qcom,spmi-temp-alarm";
176 reg = <0xa00>;
177 interrupts-extended = <&spmi_bus 0x2 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
178 #thermal-sensor-cells = <0>;
179 };
180
181 pmm8654au_1_gpios: gpio@8800 {
182 compatible = "qcom,pmm8654au-gpio", "qcom,spmi-gpio";
183 reg = <0x8800>;
184 gpio-controller;
185 gpio-ranges = <&pmm8654au_1_gpios 0 0 12>;
186 #gpio-cells = <2>;
187 interrupt-controller;
188 #interrupt-cells = <2>;
189 };
190 };
191
192 pmm8654au_2: pmic@4 {
193 compatible = "qcom,pmm8654au", "qcom,spmi-pmic";
194 reg = <0x4 SPMI_USID>;
195 #address-cells = <1>;
196 #size-cells = <0>;
197
198 pmm8654au_2_temp_alarm: temp-alarm@a00 {
199 compatible = "qcom,spmi-temp-alarm";
200 reg = <0xa00>;
201 interrupts-extended = <&spmi_bus 0x4 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
202 #thermal-sensor-cells = <0>;
203 };
204
205 pmm8654au_2_gpios: gpio@8800 {
206 compatible = "qcom,pmm8654au-gpio", "qcom,spmi-gpio";
207 reg = <0x8800>;
208 gpio-controller;
209 gpio-ranges = <&pmm8654au_2_gpios 0 0 12>;
210 #gpio-cells = <2>;
211 interrupt-controller;
212 #interrupt-cells = <2>;
213 };
214 };
215
216 pmm8654au_3: pmic@6 {
217 compatible = "qcom,pmm8654au", "qcom,spmi-pmic";
218 reg = <0x6 SPMI_USID>;
219 #address-cells = <1>;
220 #size-cells = <0>;
221
222 pmm8654au_3_temp_alarm: temp-alarm@a00 {
223 compatible = "qcom,spmi-temp-alarm";
224 reg = <0xa00>;
225 interrupts-extended = <&spmi_bus 0x6 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
226 #thermal-sensor-cells = <0>;
227 };
228
229 pmm8654au_3_gpios: gpio@8800 {
230 compatible = "qcom,pmm8654au-gpio", "qcom,spmi-gpio";
231 reg = <0x8800>;
232 gpio-controller;
233 gpio-ranges = <&pmm8654au_3_gpios 0 0 12>;
234 #gpio-cells = <2>;
235 interrupt-controller;
236 #interrupt-cells = <2>;
237 };
238 };
239 };