| 1 |
// SPDX-License-Identifier: (GPL-2.0+ OR MIT) |
| 2 |
// Copyright (C) 2020 Ondrej Jirman <[email protected]> |
| 3 |
|
| 4 |
/dts-v1/; |
| 5 |
|
| 6 |
#include "sun50i-a64-pinephone.dtsi" |
| 7 |
|
| 8 |
/ { |
| 9 |
model = "Pine64 PinePhone (1.2)"; |
| 10 |
compatible = "pine64,pinephone-1.2", "pine64,pinephone", "allwinner,sun50i-a64"; |
| 11 |
|
| 12 |
wifi_pwrseq: wifi-pwrseq { |
| 13 |
compatible = "mmc-pwrseq-simple"; |
| 14 |
reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* PL2 */ |
| 15 |
}; |
| 16 |
}; |
| 17 |
|
| 18 |
&backlight { |
| 19 |
power-supply = <®_ldo_io0>; |
| 20 |
/* |
| 21 |
* PWM backlight circuit on this PinePhone revision was changed since 1.0, |
| 22 |
* and the lowest PWM duty cycle that doesn't lead to backlight being off |
| 23 |
* is around 10%. Duty cycle for the lowest brightness level also varries |
| 24 |
* quite a bit between individual boards, so the lowest value here was |
| 25 |
* chosen as a safe default. |
| 26 |
*/ |
| 27 |
brightness-levels = < |
| 28 |
5000 5248 5506 5858 6345 |
| 29 |
6987 7805 8823 10062 11543 |
| 30 |
13287 15317 17654 20319 23336 |
| 31 |
26724 30505 34702 39335 44427 |
| 32 |
50000 |
| 33 |
>; |
| 34 |
num-interpolated-steps = <50>; |
| 35 |
default-brightness-level = <500>; |
| 36 |
}; |
| 37 |
|
| 38 |
&lis3mdl { |
| 39 |
/* |
| 40 |
* Board revision 1.2 fixed routing of the interrupt to DRDY pin, |
| 41 |
* enable interrupts. |
| 42 |
*/ |
| 43 |
interrupt-parent = <&pio>; |
| 44 |
interrupts = <1 1 IRQ_TYPE_EDGE_RISING>; /* PB1 */ |
| 45 |
}; |
| 46 |
|
| 47 |
&mmc1 { |
| 48 |
mmc-pwrseq = <&wifi_pwrseq>; |
| 49 |
}; |
| 50 |
|
| 51 |
&sgm3140 { |
| 52 |
enable-gpios = <&pio 3 24 GPIO_ACTIVE_HIGH>; /* PD24 */ |
| 53 |
flash-gpios = <&pio 2 3 GPIO_ACTIVE_HIGH>; /* PC3 */ |
| 54 |
}; |