| 1 |
/* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */ |
| 2 |
/* Copyright Fiona Klute <[email protected]> */ |
| 3 |
|
| 4 |
#ifndef __RTW8703B_H__ |
| 5 |
#define __RTW8703B_H__ |
| 6 |
|
| 7 |
#include "rtw8723x.h" |
| 8 |
|
| 9 |
extern const struct rtw_chip_info rtw8703b_hw_spec; |
| 10 |
|
| 11 |
/* phy status parsing */ |
| 12 |
#define VGA_BITS GENMASK(4, 0) |
| 13 |
#define LNA_L_BITS GENMASK(7, 5) |
| 14 |
#define LNA_H_BIT BIT(7) |
| 15 |
/* masks for assembling LNA index from high and low bits */ |
| 16 |
#define BIT_LNA_H_MASK BIT(3) |
| 17 |
#define BIT_LNA_L_MASK GENMASK(2, 0) |
| 18 |
|
| 19 |
struct phy_rx_agc_info { |
| 20 |
#ifdef __LITTLE_ENDIAN |
| 21 |
u8 gain: 7; |
| 22 |
u8 trsw: 1; |
| 23 |
#else |
| 24 |
u8 trsw: 1; |
| 25 |
u8 gain: 7; |
| 26 |
#endif |
| 27 |
} __packed; |
| 28 |
|
| 29 |
/* This struct is called phy_status_rpt_8192cd in the vendor driver, |
| 30 |
* there might be potential to share it with drivers for other chips |
| 31 |
* of the same generation. |
| 32 |
*/ |
| 33 |
struct phy_status_8703b { |
| 34 |
struct phy_rx_agc_info path_agc[2]; |
| 35 |
u8 ch_corr[2]; |
| 36 |
u8 cck_sig_qual_ofdm_pwdb_all; |
| 37 |
/* for CCK: bits 0:4: VGA index, bits 5:7: LNA index (low) */ |
| 38 |
u8 cck_agc_rpt_ofdm_cfosho_a; |
| 39 |
/* for CCK: bit 7 is high bit of LNA index if long report type */ |
| 40 |
u8 cck_rpt_b_ofdm_cfosho_b; |
| 41 |
u8 reserved_1; |
| 42 |
u8 noise_power_db_msb; |
| 43 |
s8 path_cfotail[2]; |
| 44 |
u8 pcts_mask[2]; |
| 45 |
s8 stream_rxevm[2]; |
| 46 |
u8 path_rxsnr[2]; |
| 47 |
u8 noise_power_db_lsb; |
| 48 |
u8 reserved_2[3]; |
| 49 |
u8 stream_csi[2]; |
| 50 |
u8 stream_target_csi[2]; |
| 51 |
s8 sig_evm; |
| 52 |
u8 reserved_3; |
| 53 |
|
| 54 |
#ifdef __LITTLE_ENDIAN |
| 55 |
u8 antsel_rx_keep_2: 1; |
| 56 |
u8 sgi_en: 1; |
| 57 |
u8 rxsc: 2; |
| 58 |
u8 idle_long: 1; |
| 59 |
u8 r_ant_train_en: 1; |
| 60 |
u8 ant_sel_b: 1; |
| 61 |
u8 ant_sel: 1; |
| 62 |
#else /* __BIG_ENDIAN */ |
| 63 |
u8 ant_sel: 1; |
| 64 |
u8 ant_sel_b: 1; |
| 65 |
u8 r_ant_train_en: 1; |
| 66 |
u8 idle_long: 1; |
| 67 |
u8 rxsc: 2; |
| 68 |
u8 sgi_en: 1; |
| 69 |
u8 antsel_rx_keep_2: 1; |
| 70 |
#endif |
| 71 |
} __packed; |
| 72 |
|
| 73 |
/* Baseband registers */ |
| 74 |
#define REG_BB_PWR_SAV5_11N 0x0818 |
| 75 |
/* BIT(11) should be 1 for 8703B *and* 8723D, which means LNA uses 4 |
| 76 |
* bit for CCK rates in report, not 3. Vendor driver logs a warning if |
| 77 |
* it's 0, but handles the case. |
| 78 |
* |
| 79 |
* Purpose of other parts of this register is unknown, 8723cs driver |
| 80 |
* code indicates some other chips use certain bits for antenna |
| 81 |
* diversity. |
| 82 |
*/ |
| 83 |
#define REG_BB_AMP 0x0950 |
| 84 |
#define BIT_MASK_RX_LNA (BIT(11)) |
| 85 |
|
| 86 |
/* 0xaXX: 40MHz channel settings */ |
| 87 |
#define REG_CCK_TXSF2 0x0a24 /* CCK TX filter 2 */ |
| 88 |
#define REG_CCK_DBG 0x0a28 /* debug port */ |
| 89 |
#define REG_OFDM0_A_TX_AFE 0x0c84 |
| 90 |
#define REG_TXIQK_MATRIXB_LSB2_11N 0x0c9c |
| 91 |
#define REG_OFDM0_TX_PSD_NOISE 0x0ce4 /* TX pseudo noise weighting */ |
| 92 |
#define REG_IQK_RDY 0x0e90 /* is != 0 when IQK is done */ |
| 93 |
|
| 94 |
/* RF registers */ |
| 95 |
#define RF_RCK1 0x1E |
| 96 |
|
| 97 |
#define AGG_BURST_NUM 3 |
| 98 |
#define AGG_BURST_SIZE 0 /* 1K */ |
| 99 |
#define BIT_MASK_AGG_BURST_NUM (GENMASK(3, 2)) |
| 100 |
#define BIT_MASK_AGG_BURST_SIZE (GENMASK(5, 4)) |
| 101 |
|
| 102 |
#endif /* __RTW8703B_H__ */ |