| 1 |
The GCTP FORTRAN version and GCTPc have differences with the UTM projection |
| 2 |
as the zones are not handled the same. GCTPc will use the entered zone first, |
| 3 |
positive or negative. If zone is zero, the first two values in the parameter |
| 4 |
array (See Projection Parameters documentation) will be used to calculate the |
| 5 |
zone. |
| 6 |
|
| 7 |
The original tests comparing C and Fortran were done in several steps. |
| 8 |
Three zones (negative CM, positive CM, and CM around zero) were tested with |
| 9 |
both positive and negative zones on all systems against the FORTRAN version. |
| 10 |
Then a file was made setting zone to zero and the parameter array lat and long |
| 11 |
were used. This file was compared to GCTPc's file with the appropriate zone |
| 12 |
entered. Also, files were made with each zone and transported to the other |
| 13 |
systems and compared. |
| 14 |
|
| 15 |
Note: Since the UTM projection is intended to be used for relatively small |
| 16 |
regions, the test grids are set to cover smaller areas than for global maps. |
| 17 |
As projected points get further from the central meridian, the projected values |
| 18 |
are less reliable. Any points more than 90 degrees either side of the |
| 19 |
central meridian were not tested. |
| 20 |
|
| 21 |
|