Debian Codegraph @

debian/default

raw
1 # This file is used to configure htpdate daemon. Most users needn't change
2 # anything here.
3
4 # htpdate will run on system boot as daemon and at every network restart
5 # (IF UP). However you can disable each one uncommenting the following lines.
6 # But IF YOUR SYSTEM ARE USING SYSTEMD (Debian Jessie and newer use it!),
7 # the first line will be ignored. You can use '# systemctl disable htpdate'
8 # to disable htpdate on boot and '# systemctl enable htpdate' to reenable it.
9 # HTP_DAEMON=no
10 # HTP_IFUP=no
11
12 # If you have a HTTP proxy, uncomment the following line and change the
13 # values.
14 # HTP_PROXY="-P myproxy-xyz.com:8080"
15
16 # In the next line you should put HTTP servers. Note that htpdate uses
17 # the timestamps extracted from headers to synchronize the time. You
18 # must to use reliable servers only. Remember: you can use any site, not
19 # specifics NTP site only.
20 HTP_SERVERS="www.ntp.org www.example.com"
21
22 # The general options can be viewed with '$ htpdate -h'. However, you can
23 # keep the current options, that works fine.
24 HTP_OPTIONS="-D -s"