| 1 |
To setup the project and upload the Arduino usbserial application firmware to an ATMEGA8U2 using the Arduino USB DFU bootloader: |
| 2 |
1. unpack the source into LUFA's Projects directory |
| 3 |
2. set ARDUINO_MODEL_PID in the makefile as appropriate |
| 4 |
3. do "make clean; make" |
| 5 |
4. put the 8U2 into USB DFU mode: |
| 6 |
4.a. assert and hold the 8U2's RESET line |
| 7 |
4.b. assert and hold the 8U2's HWB line |
| 8 |
4.c. release the 8U2's RESET line |
| 9 |
4.d. release the 8U2's HWB line |
| 10 |
5. confirm that the board enumerates as either "Arduino Uno DFU" or "Arduino Mega 2560 DFU" |
| 11 |
6. do "make dfu" (OS X or Linux - dfu-programmer must be installed first) or "make flip" (Windows - Flip must be installed first) |
| 12 |
|
| 13 |
Check that the board enumerates as either "Arduino Uno" or "Arduino Mega 2560". Test by uploading a new Arduino sketch from the Arduino IDE. |