Debian Codegraph @

coraid-update

raw
1 #! /bin/sh
2 # usage: coraid-update {update file} {AoE target}
3 # coraid-update depends upon sysfs mounted on /sys
4
5 # The destination must be,
6 # 1) an AoE target ready for I/O, and
7 # 2) not too big to be an update target
8 #
9 # Later, when CORAID appliances mark update targets with special ATA
10 # device identify content or special target content, a prompt should
11 # be added after the check of the target's size if the identifying
12 # content is not detected.
13 #
14 # The update file must either,
15 # 1) be an SR tarc file that looks OK to the local tar, or
16 # 2) any file not ending in ".tarc".
17
18 # size of update LUN in /proc/partitions is 40000
19 max=70000
20
21 usage="usage: coraid-update {update file} {AoE device}"
22 if test "$#" != 2; then
23 echo "$usage" 1>&2
24 exit 1
25 fi
26 update="$1"
27 ulb="$2"
28
29 # if it's an update target, it should be in `aoe-stat`
30 aoe-stat | awk -vt="`basename $ulb`" '
31 BEGIN{fail=1}
32 $1==t{fail=0}
33 END{exit fail}' || {
34 exec 1>&2
35 echo "coraid-update Error: \"$ulb\" is not an AoE target"
36 echo "$usage"
37 exit 1
38 }
39
40 # it should have a size no larger than $max in /proc/partitions
41 t="`echo $ulb | sed 's!^/dev/!!'`"
42 awk -vt="$t" '$NF==t{print $3}' /proc/partitions |
43 awk -vhi=$max -vdev="$ulb" '
44 BEGIN{
45 err = "could not get size of " dev
46 } {
47 err = "none"
48 if ($1 > hi) {
49 err = dev " is too large to be an update target"
50 exit
51 }
52 } END{
53 if (err != "none") {
54 print "Error coraid-update: " err > "/dev/stderr"
55 exit 1
56 }
57 exit 0
58 }' || exit 1
59
60 # this test should be removed when it is performed on the appliance
61 #
62 # For a 2734080-byte tarc file, an incomplete file of 2727450 bytes passes
63 # this test, but one of 2727400 does not. So this test isn't fullproof.
64 #
65 if test "`echo \"$update\" | grep '\.tarc$'`"; then
66 tar tf "$update" > /dev/null 2>&1 || {
67 exec 1>&2
68 echo "coraid-update Error: \"$update\" does not appear to be a valid tarc file"
69 exit 1
70 }
71 fi
72 if test ! -r "$update"; then
73 echo "coraid-update Error: \"$update\" is not readable" 1>&2
74 exit 1
75 fi
76
77 # send it over and complain on error
78 if ! dd if="$update" of="$ulb" 2> /dev/null || ! sync; then
79 exec 1>&2
80 echo "coraid-update Error: could not successfully write \"$update\" to \"$ulb\""
81 exit 1
82 fi