(2016/11/22) This is the simplest CI server you can possibily imagine. I looked at setting this up with the TriBITS Dashboard Driver (TDD) system but that is such an ugly system that I just could not go through with it. Therefore, I have decided that I am going to abandon that old system and create a new TriBITS Dashboard Driver Plus system that is the most simple and minimal possible to use CMake/CTest/CDash to drive and monitor the ctest -S script invocations. But until I can do that, I went with a simple appraoch described below. To get this set up on a new machine, just do: mkdir cd / git clone -b develop git@github.com:trilinos/Trilinos.git Then create a cronjob (or Jenkins job) that does: cd / && ./Trilinos/cmake/ctest/drivers/sems_ci/trilinos_ci_sever.sh \ &> trilinos_ci_sever.out That is it! To set up this simple system, I started with a basic ctest -S driver script: ctest_linux_mpi_debug_shared_pt_ci.sems.cmake using TribitsCTestDriverCore.cmake (just like any other automated Trilinos build). Then I call that in a simple shell script: single_ci_iter.sh which just sources the standard SEMS env script and calls the ctest -S driver script. The last part to this simple CI server is the script: trilinos_ci_sever.sh which uses the simple Python script generic-looping-demon.py to do the CI loops. That is it! To debug the setup, run the script with: cd / env \ Trilinos_PACKAGES=Kokkos,Teuchos \ CTEST_DO_UPDATES=OFF \ CTEST_DO_SUBMIT=OFF \ TRILINOS_CI_SKIP_EMAILS=1 \ ./Trilinos/cmake/ctest/drivers/sems_ci/trilinos_ci_sever.sh \ &> trilinos_ci_sever.out and then kill the command once you see what you need to see. To have the CI build do a rebuild from scratch at the start, set the env var: TRILINOS_CI_DO_INITIAL_REBUILD=1 NOTE: There are a few major weaknesses to this approach: 1) If a change is made to the build systems for Trilinos (i.e. in Trilinos or TriBITS), then the you may get an error since the version of ctest_linux_mpi_debug_shared_pt_ci.sems.cmake and TribitsCTestDriverCore.cmake that runs may not be consistent with the updated version of Trilinos and TriBITS that is pulled by TribitsCTestDriverCore.cmake. If that happens, one just needs to kill trilinos_ci_server.sh (using kill-pstree.py) and just run it again with nohup. 2) If something goes wrong in the early stages of the CTest -S drivers script, then the CI build is just not uploaded to the Trilinos CDash site and we can't see if there are any failures. 3) If things go well, the only way to see what the ctest -S script is doing is to look at the local trilinos_ci_server.out log file (since it never gets posted to a CDash site). Therefore, this is a temporary solution until we can get something better in place using a combination of CMake/CTest/CDash and/or Jenkins.