# # Start backup, but dont wait for it to complete # - also save the number of "Backup records" in DBLQH before start, this value # is later used to wait for backup to complete in ndb_backup_nowait_wait.inc # # Save backup id before backup start --source include/ndb_backup_id.inc let $_pre_backup_id = $the_backup_id; # Save backup records in BACKUP before backup start let $start_backup_records_in_use = `SELECT SUM(used) from ndbinfo.ndb\\\$pools WHERE block_number=244 AND pool_name = "Backup Record"`; # Print start backup message, show any extra parameters let $_start_backup_msg = Starting backup; if ($start_backup_extra){ let $_start_backup_msg = Starting $start_backup_extra backup; } echo $_start_backup_msg; # Use WAIT STARTED rather than NOWAIT # NOWAIT does not wait for a BACKUP_CONF in MGMD, and so does not handle e.g. # the case where MGMD sends the BACKUP_REQ to the wrong Master. This could # result in no backup being started, silently, resulting in test case # failures --let $START_BACKUP_OUTFILE=$MYSQLTEST_VARDIR/tmp/start_backup_outfile.txt --exec $NDB_MGM -e "start backup $start_backup_extra wait started" >> $START_BACKUP_OUTFILE # Make sure that backup id has increased (this is a sanity check that backup # has changed state) # --source include/ndb_backup_id.inc if ($the_backup_id <= $_pre_backup_id) { echo Pre backup id: $_pre_backup_id; echo The backup id: $the_backup_id; echo Start backup extra: "$start_backup_extra"; echo Start backup records: $start_backup_records_in_use; echo === Dumping log from "start backup" ==; cat_file $START_BACKUP_OUTFILE; echo === =============================== ==; die The backup id was not increased during start of backup; } --remove_file $START_BACKUP_OUTFILE # NOTE! When using this include file without stalling the backup with an # error insert it might even have completed at this point --echo Backup started # Reset parameters let $start_backup_extra =;