0) ? 32 : 16;
$m = (strpos($PAGE, '_mono') > 0) ? 'm' : (
(strpos($PAGE, '_stereo') > 0) ? 's' : (
(strpos($PAGE, '_lr') > 0) ? 'lr' : (
(strpos($PAGE, '_ms') > 0) ? 'ms' : '?'
)));
$cc = ($m == 'm') ? 'mono' : 'stereo';
?>
This plugin performs graphic equalization of = $cc ?> channel. Up to = $nf ?> frequency bands are available for correction in range of 72 dB (-36..+36 dB).
Meters:
- Input - the level meter for left and right channels of the input signal.
If Listen button is pressed, it shows the level of middle and side channels of the input signal respectively.
- Output - the level meter for left and right channels of the output signal.
If Listen button is pressed, it shows the level of middle and side channels of the output signal respectively.
- Input - the level meter for left and right channels of the input signal.
- Output - the level meter for left and right channels of the output signal.
- Input - the level meter of the input mono signal.
- Output - the level meter of the output mono signal.
Controls:
-
Bypass - bypass switch, when turned on (led indicator is shining), the plugin bypasses signal.
- Mode - equalizer slope and working mode, enables the following settings:
- BT48 - Filters with 48dB/oct slope, bilinear Z-transform.
- MT48 - Filters with 48dB/oct slope, matched Z-transform.
- BT72 - Filters with 72dB/oct slope, bilinear Z-transform.
- MT72 - Filters with 72dB/oct slope, matched Z-transform.
- BT96 - Filters with 96dB/oct slope, bilinear Z-transform.
- MT96 - Filters with 96dB/oct slope, matched Z-transform.
- IIR - Infinite Impulse Response filters, nonlinear minimal phase. In most cases does not add noticeable latency to output signal.
- FIR - Finite Impulse Response filters with linear phase, finite approximation of equalizer's impulse response. Adds noticeable latency to output signal.
- FFT - Fast Fourier Transform approximation of the frequency chart, linear phase. Adds noticeable latency to output signal.
- SPM - Spectral Processor Mode of equalizer, equalizer transforms the magnitude of signal spectrum instead of applying impulse response to the signal.
- L/R Link - enables linking between Left and Right channel controls so change of one forces the sibling to become the same value.
- M/S Link - enables linking between Mid and Side channel controls so change of one forces the sibling to become the same value.
- Mid - button enables the frequency chart and FFT analysis for the middle channel, knob allows to adjust the level of the middle channel.
- Side - button enables the frequency chart and FFT analysis for the side channel, knob allows to adjust the level of the side channel.
- Listen - allows to listen middle channel and side channel. Passes middle channel to the left output channel, side channel to the right output channel.
- Left - enables the FFT analysis for the left channel.
- Right - enables the FFT analysis for the right channel.
- Zoom - zoom fader, allows to adjust zoom on the frequency chart.
'Signal' section:
- Input - input signal amplification.
- Output - output signal amplification.
- Balance - balance between left and right output signal.
'Analysis' section:
- FFT - enables FFT analysis before or after filter processing stage.
- Reactivity - the reactivity (smoothness) of the spectral analysis.
- Shift - allows to adjust the overall gain of the analysis.
'Bands' section:
- On - enables the filter for the corresponding band.
- S - the soloing button, allows to inspect corresponding band.
- M - the mute button, allows to mute corresponding filters.
- Gain - the amplifiction gain of the band.