# $Id$ # # Configuration for a Rockwell/Conexant K56 Class 1.0 modem using # the RCV56DPF and similar chipsets. These chipsets are generally # flash- upgradable and appear on ISA as well as PCI. They # support "Class 1.0" which means that they have "adaptive receive" # (AT+FAR=1), but not V.34. # # Comtrol RocketModem II/III/IV # MultiTech MT5600ZDX # Zoltrix FMVSP56i3 # # CONFIG:CLASS1.0:56000:.*:.*: Manufacturer=Rockwell/Conexant Model=AC/K56 # CONFIG:CLASS1.0:MT5600ZDX:.*:.*: Manufacturer=MultiTech Model=MT5600ZDX # CONFIG:CLASS1.0:MT5656ZDX:.*:.*: Manufacturer=MultiTech Model=MT5656ZDX # CONFIG:CLASS1.0:.*:.*LEONARDO.*:.*: Manufacturer=Digicom Model=Leonardo # # BEGIN-SERVER # END-SERVER # # Modem-related stuff: should reflect modem command interface # and hardware connection/cabling (e.g. flow control). # ModemType: Class1.0 # use this to supply a hint ModemRate: 19200 # rate for DCE-DTE communication ModemFlowControl: rtscts # default # # With the RocketModem IV (and possibly III) you may need to use a much # higher ModemRate than 19200 because, apparently, it suffers from potential # buffer underrun problems. Fortunately, it doesn't have buffer overflow # issues, and so using 115200 should work (both rtscts and xonxoff test good). # ModemNoFlowCmd: AT&K0 # setup no flow control ModemHardFlowCmd: AT&K3 # setup hardware flow control ModemSoftFlowCmd: AT&K4 # setup software flow control ModemSetupDTRCmd: AT&D2 # setup so DTR drop resets modem ModemSetupDCDCmd: AT&C1 # setup so DCD reflects carrier (or not) # Class1AdaptRecvCmd: AT+FAR=1 # reports carrier detection mismatches