#!/bin/csh module swap PrgEnv-pgi PrgEnv-gnu setenv CC cc setenv CXX CC setenv OPT '-O3 -funroll-all-loops' # edit the installation paths if necessary mkdir -p sw/xt5 cd sw/xt5 set sw_home=`pwd` setenv EXPAT_DIR ${sw_home}/expat-2.0.1-1 setenv ZLIB_DIR ${sw_home}/zlib-1.2.3-1 setenv PYTHON_DIR ${sw_home}/Python-2.5.4-1 wget https://www.python.org/ftp/python/2.5.4/Python-2.5.4.tar.bz2 wget https://sunet.dl.sourceforge.net/sourceforge/expat/expat-2.0.1.tar.gz wget https://www.zlib.net/zlib-1.2.3.tar.bz2 tar jxf Python-2.5.4.tar.bz2 tar zxf expat-2.0.1.tar.gz tar jxf zlib-1.2.3.tar.bz2 wget https://python-nose.googlecode.com/files/nose-0.11.0.tar.gz tar zxf nose-0.11.0.tar.gz wget https://dfn.dl.sourceforge.net/sourceforge/numpy/numpy-1.2.1.tar.gz tar zxf numpy-1.2.1.tar.gz cd ${sw_home} echo "Making Expat" cd expat-2.0.1 ./configure --disable-shared --prefix=${EXPAT_DIR} make make install cd ${sw_home} echo "Making Zlib" cd zlib-1.2.3 ./configure --prefix=${ZLIB_DIR} make # ignore error: /usr/lib/../lib64/libc.a: could not read symbols: Bad value make install cd ${sw_home} echo "Making Python" cd Python-2.5.4 wget --no-check-certificate https://svn.fysik.dtu.dk/projects/gpaw/trunk/doc/install/Cray/dynload_redstorm.c -O Python/dynload_jaguar.c ./configure --prefix=${PYTHON_DIR} SO=.a DYNLOADFILE=dynload_jaguar.o MACHDEP=jaguar --host=x86_64-unknown-linux-gnu --disable-sockets --disable-ssl --enable-static --disable-shared | tee config.log wget --no-check-certificate https://svn.fysik.dtu.dk/projects/gpaw/trunk/doc/install/Cray/linkforshared.py cat Lib/distutils/unixccompiler.py linkforshared.py > unixccompiler.py mv -f unixccompiler.py Lib/distutils mv -f Modules/Setup Modules/Setup.orig wget --no-check-certificate https://svn.fysik.dtu.dk/projects/gpaw/trunk/doc/install/Cray/Setup_jaguar -O Modules/Setup touch Modules/Setup make | tee make.log # ignore errors like: # *** WARNING: renaming "_ctypes" since importing it failed: dynamic module does not define init function (init_ctypes) make install | tee make_install.log cd ${sw_home} echo "Making Numpy" cd numpy-1.2.1 ${PYTHON_DIR}/bin/python setup.py install | tee install.log cd ${sw_home}/Python-2.5.4 echo "Remaking Python" cat ../numpy-1.2.1/install.log | grep Append | cut -d ":" -f 2 | sed -n 's/ *//p' > append cat Modules/Setup append > Setup mv -f Setup Modules make | tee make2.log make install | tee make_install2.log