package ipmi import ( "context" "errors" "fmt" ) // [DCMI specification v1.5]: 6.7.1 Get Thermal Limit Command type GetDCMIThermalLimitRequest struct { EntityID EntityID // Entity ID = 37h or 40h (Inlet Temperature) EntityInstance EntityInstance } type GetDCMIThermalLimitResponse struct { ExceptionAction_PowerOffAndLogSEL bool ExceptionAction_LogSELOnly bool // ignored if ExceptionAction_PowerOffAndLogSEL is true // Temperature Limit set in units defined by the SDR record. // Note: the management controller is not required to check this parameter for validity against the SDR contents. TemperatureLimit uint8 // Interval in seconds over which the temperature must continuously be sampled as exceeding the set limit // before the specified Exception Action will be taken. // Samples are taken at the rate specified by the sampling frequency value in parameter #5 of the DCMI Capabilities // parameters (see Table 6-3, DCMI Capabilities Parameters). ExceptionTimeSec uint16 } func (req *GetDCMIThermalLimitRequest) Pack() []byte { return []byte{GroupExtensionDCMI, byte(req.EntityID), byte(req.EntityInstance)} } func (req *GetDCMIThermalLimitRequest) Command() Command { return CommandGetDCMIThermalLimit } func (res *GetDCMIThermalLimitResponse) CompletionCodes() map[uint8]string { return map[uint8]string{} } func (res *GetDCMIThermalLimitResponse) Unpack(msg []byte) error { if len(msg) < 5 { return ErrUnpackedDataTooShortWith(len(msg), 5) } if err := CheckDCMIGroupExenstionMatch(msg[0]); err != nil { return err } b1, _, _ := unpackUint8(msg, 1) res.ExceptionAction_PowerOffAndLogSEL = isBit6Set(b1) res.ExceptionAction_LogSELOnly = isBit5Set(b1) res.TemperatureLimit, _, _ = unpackUint8(msg, 2) res.ExceptionTimeSec, _, _ = unpackUint16L(msg, 3) return nil } func (res *GetDCMIThermalLimitResponse) Format() string { return "" + "Exception Actions, taken if the Temperature Limit exceeded:\n" + fmt.Sprintf(" Hard Power Off system and log event : %s\n", formatBool(res.ExceptionAction_PowerOffAndLogSEL, "active", "inactive")) + fmt.Sprintf(" Log event to SEL only : %s\n", formatBool(res.ExceptionAction_LogSELOnly, "active", "inactive")) + fmt.Sprintf(" Temperature Limit : %d degrees\n", res.TemperatureLimit) + fmt.Sprintf(" Exception Time : %d seconds\n", res.ExceptionTimeSec) } func (c *Client) GetDCMIThermalLimit(ctx context.Context, entityID EntityID, entityInstance EntityInstance) (response *GetDCMIThermalLimitResponse, err error) { if uint8(entityID) != 0x37 && uint8(entityID) != 0x40 { return nil, errors.New("only Inlet Temperature entityID (0x37 or 0x40) is supported") } request := &GetDCMIThermalLimitRequest{ EntityID: entityID, EntityInstance: entityInstance, } response = &GetDCMIThermalLimitResponse{} err = c.Exchange(ctx, request, response) return }