Form
0
0
498
541
Form
-
QFrame::StyledPanel
QFrame::Raised
-
Tool Controller
-
The tool and its settings to be used for this operation
-
Coolant mode
-
The tool and its settings to be used for this operation
-
Edit Tool Controller
-
-
Bounding box
-
Select the overall boundary for the operation
-
Scan type
-
Planar: flat, 3D surface scan. Rotational: 4th-axis rotational scan.
-
Layer mode
-
Complete the operation in a single pass at depth, or multiple passes to final depth
-
Cut pattern
-
Set the geometric clearing pattern to use for the operation
-
Profile edges
-
Profile the edges of the selection
-
Avoid last X faces
-
Avoid cutting the last 'n' faces in the base geometry list of selected faces
-
Bounding box extra offset X, Y
-
-
0
0
Additional offset to the selected bounding box along the X axis
mm
-
Additional offset to the selected bounding box along the Y axis
mm
-
Drop cutter direction
-
Dropcutter lines are created parallel to this axis.
-
Depth offset
-
Set the Z-axis depth offset from the target surface
mm
-
Stepover
-
The amount by which the tool is laterally displaced on each cycle of the pattern, specified in percent of the tool diameter.
A step over of 100% results in no overlap between two different cycles.
1
100
-
Sample interval
-
Set the sampling resolution. Smaller values quickly increase processing time.
mm
-
Set to true if specifying a start point
Use start point
-
Enable optimization of linear paths (co-linear points). Removes unnecessary co-linear points from G-code output.
Optimize linear paths
-
If true, the cutter will remain inside the boundaries of the model or selected faces
Boundary enforcement
true
-
Enable separate optimization of transitions between, and breaks within, each step over path.
Optimize stepover transitions
-
Qt::Vertical
20
40
Gui::InputField
QLineEdit