# zonemap Normally Foomuuri will map incoming and outgoing traffic to zones by source and destination network interface. These interfaces are assigned to zones dynamically by NetworkManager, or configured in [zone](zone.md) section. Zonemap section can be used to map traffic to different zone by using standard [rules](../rule/index.md). Example: ``` zonemap { # Map outgoing IPsec traffic that is going to zone "public" to use zone # "vpn" instead. dipsec dzone public new_dzone vpn # Same for incoming. sipsec szone public new_szone vpn } localhost-public { # Rules for non-IPsec traffic ipsec # You must allow IPsec traffic here and in public-localhost ...accept some traffic... reject log } localhost-vpn { # Rules for IPsec traffic ...accept some traffic... reject log } ``` Above example, splitting traffic to IPsec and non-IPsec zones is the most common use case. You can use any matcher, for example `daddr` or `saddr` to map some IP addresses to own zones, or `uid` or `gid` to map outgoing traffic from some local user to own zone: ``` zonemap { # Map IP address 10.2.3.0/24 from internal to dmz saddr 10.2.3.0/24 szone internal new_szone dmz daddr 10.2.3.0/24 dzone internal new_dzone dmz # Map outgoing traffic from user myservice to myzone uid myservice szone localhost new_szone myzone # Map all outgoing IPsec traffic to xxx-vpn, no matter what the original # dzone was dipsec new_dzone vpn } ```